Abstract:In modern gas turbines, efforts are being made to improve efficiency even further. This is achieved primarily by increasing the generated pressure ratio in the compressor and by increasing the turbine inlet temperature. This leads to enormous loads on the components in the hot gas region in the turbine. As a result, non-destructive testing and structural health monitoring (SHM) processes are becoming increasingly important to gas turbine manufacturers. Initial cracks in the turbine blades must be identified before catastrophic events occur. A proven method is the linear ultrasound method. By monitoring the amplitude and phase fluctuations of the input signal, structural integrity of the components can be detected. However, closed cracks or small cracks cannot be easily detected due to a low impedance mismatch with the surrounding materials. By contrast, nonlinear ultrasound methods have shown that damages can be identified at an early stage by monitoring new signal components such as sub- and higher harmonics of the fundamental frequency in the frequency spectrum. These are generated by distortion of the elastic waveform due to damage/nonlinearity of the material. In this paper, new global nonlinear parameters were derived that result from the dual excitation of two different ultrasound frequencies. These nonlinear features were used to assess the presence of cracks as well as their qualitative sizes. The proposed approach was tested on several samples and turbine blades with artificial and real defects. The results were compared to samples without failure. Numerical simulations were conducted to investigate nonlinear elastic interaction of the stress waves with the damage regions. The results show a clear trend of nonlinear parameters changing as a function of the crack size, demonstrating the capability of the proposed approach to detect in-service cracks.

A Crack Detection Method for Aero-engine Blade Based on Air-Flow Thermography

Fatigue Crack Propagation Analysis in an Aero-Engine Turbine Disc Using Computational Methods and Spin Test

A Hybrid Modeling Method of Fatigue Crack Growth for Gas Turbine Blades under Combined High and Low Cycle Fatigue Loadings

On-Site Non-contact Detection of the Cracks in Aeroengine Blades by Alternating Current Field Measurement Technique

Automated Crack Detection With Image Analysis for the Blades of Steam Turbine

Nonlinear vibration characteristics and damage detection method of blade with breathing fatigue crack

Infrared Thermal Imaging-Based Turbine Blade Crack Classification Using Deep Learning

An Analytical Representation Method for Dynamic Behavior of Rotating Blade with Transverse Crack

Crack Diagnosis of Wind Turbine Blades Based on EMD Method

Dynamic characteristic analysis of rotating blade with breathing crack

Blade tip characteristics of turbine disks with cracks

An improved analytical dynamic model for rotating blade crack: With application to crack detection indicator analysis

Prediction of Fatigue Crack Growth in Gas Turbine Engine Blades Using Acoustic Emission

Pulsed Air-Flow Thermography for Natural Crack Detection and Evaluation

Digital Twin-Driven Crack Monitoring for Rotating Blade: an L1 Regularization Method

Fatigue crack propagation simulation of airfoil section blade under aerodynamic and centrifugal loads

Quantitative Detection Method for Surface Angled Cracks Based on Laser Ultrasonic Full-Field Scanning Data

Dynamic modeling and verification of rotating compressor blade with crack based on beam element

A Nonlinear Ultrasonic Modulation Method for Crack Detection in Turbine Blades

Crack modeling of rotating blades with cracked hexahedral finite element method

Blade Crack Detection Using Blade Tip Timing