Synergistic Corrosion Inhibition of Rubber Seed Extract with KI on Cold Rolled Steel in Sulfuric Acid Solution
Xueyan Teng,Shuduan Deng,Xianghong Li
DOI: https://doi.org/10.1016/j.jtice.2024.105564
IF: 5.477
2024-01-01
Journal of the Taiwan Institute of Chemical Engineers
Abstract:Background: Plant-based inhibitor has emerged an important topic owing to the combing merits of eco-friendly, low cost, rich natural resources as well as easy preparation. Rubber seed is the agricultural waste, and is mainly composed of oil and fatty acids those contain many polar oxygen atoms, and so it can be extracted to prepare the potential corrosion inhibitor. Methods: Rubber seed extract (RSE) is prepared using reflux extraction method with the extracting solvent of ethanol aqueous solution. The synergistic inhibition effect of RSE and potassium iodide (KI) on the corrosion of cold rolled steel (CRS) in 0.50 M H2SO4 solution is firstly studied by weight loss, potentiodynamic polarization (PDP) curves and electrochemical impedance spectroscopy (EIS) methods. CRS surface was thoroughly characterized using metallographic microscope, scanning electron microscope (SEM), atomic force microscope (AFM), X-ray photoelectron spectroscopy (XPS) and contact angle measurements. FTIR, UV-vis and liquid chromatography mass spectrometry (LC-MS) compositional analysis of RSE were used to analyze the efficient components in RSE. Significant findings: The results indicate that individual RSE or KI cannot function as a successful inhibitor to prevent CRS corrosion, but the mixture of RSE/KI performs better at inhibiting, with a maximal inhibition efficacy of up to 96.4% of 200 mg L- 1 RSE/100 mg L- 1 KI. The synergistic coefficient of the mixture is larger than 1, indicating that a true synergism. RSE/KI can drastically retard both cathodic and anodic processes, and interfacial capacitance falls as the charge transfer resistance of CRS/solution rises. It exhibits remarkable inhibition properties when the capacitor arc grows. There is only a small corrosion response in the inhibited media, as evidenced by the variations in electrical conductivity and ultraviolet spectrum before and after immersion. The hydrophilicity and surface roughness of CRS surface is dropped as a result of the introduction of RSE/KI. A series of metallurgical microscopy, AFM, SEM or contact angle tests indicate a synergistic inhibition effect is more pronounced for RSE/KI. XPS results clearly demonstrate that elements including Fe, S, N, and I are bonded to the surface of CRS. The primary ingredients of oleic acid, polyphenols, phenylpropanoids can also produce a strong synergism with KI.