Abstract:An increasing number of experiments require the use of ultrasensitive nanomechanical resonators. Relevant examples are the investigation of quantum effects in mechanical systems [1] or the detection of exceedingly small forces as in Magnetic Resonance Force Microscopy (MRFM) [2]. The force sensitivity of a mechanical resonator is typically limited by thermal fluctuations, which calls for detection methods capable of operating at ultralow temperature. Commonly used interferometric techniques, despite their excellent sensitivity, may not be an optimal choice at millikelvin temperatures, because of unwanted resonator heating caused by photon absorption. Although alternative detection techniques based on microwave cavities [3] [4] [5] have shown to perform better at ultralow temperature, these techniques still suffer from the fact that the detection sensitivity decreases as the power input is decreased. Here, we present a measurement approach based on the detection, through a Superconducting Quantum Interference Device (SQUID), of the change of magnetic flux induced in a coil by the motion of a magnetic particle attached to a resonator. This detection scheme avoids direct heating of the resonator, as it does not involve reflecting optical or microwave photons to the resonator. By cooling an ultrasoft silicon resonator to 25 mK, we achieve a force noise of 0.5 aN in a 1 Hz bandwidth. We believe this detection technique can in principle be used even at sub-millikelvin temperatures. Furthermore, it could be used to improve the sensitivity of MRFM experiments, which aim at three dimensional imaging at atomic resolution.

Ultrasensitive hysteretic force sensing with parametric nonlinear oscillators

Ultrasensitive charge detection utilizing coupled nonlinear micromechanical resonators

Ultrasensitive force detection with a nanotube mechanical resonator

Detection of weak stochastic force in a parametrically stabilized micro opto-mechanical system

Force Detection Sensitivity Spectrum Calibration of Levitated Nanomechanical Sensor Using Harmonic Coulomb Force

A hybrid on-chip opto-nanomechanical transducer for ultra-sensitive force measurements

Ultrasensitive Resonant Electrometry Utilizing Micromechanical Oscillators

Demonstration of Motion Transduction Based on Parametrically Coupled Mechanical Resonators

Yoctonewton force detection based on optically levitated oscillator

Single-electron Detection Utilizing Coupled Nonlinear Microresonators

Weak Force Sensing Based on Optical Parametric Amplification in a Cavity Optomechanical System Coupled in Series with Two Oscillators

Kinetic Inductive Electromechanical Transduction for Nanoscale Force Sensing

Parametrically driven inertial sensing in chip-scale optomechanical cavities at the thermodynamical limits with extended dynamic range

Thermal nonlinearities in a nanomechanical oscillator

Internal resonance in coupled oscillators – Part II: A synchronous sensing scheme for both mass perturbation and driving force with duffing nonlinearity

Sensing of Static Forces with Free-Falling Nanoparticles

A SQUID based read-out of sub-attoNewton force sensor operating at millikelvin temperatures

A nanonewton force sensor using a U-shape tapered microfiber interferometer

Quantum Lock-in Force Sensing using Optical Clock Doppler Velocimetry

Weak signal enhancement by non-linear resonance control in a forced nano-electromechanical resonator