Abstract:Introduction: Total knee arthroplasty (TKA) is a complex surgical procedure that traditionally relies on two-dimensional radiographs for pre-operative planning. These radiographs may not capture the intricate details of individual knee anatomy, potentially limiting the precision of surgical interventions. With advancements in imaging technology, there is an opportunity to refine TKA outcomes. This study introduces the Native Alignment Phenotype classification system that is based on pre-operative 3-dimensional computed tomography (CT) scans, aiming to provide a more detailed understanding of knee deformities and their influence on characterizing knee osteoarthritis and planning for TKA procedures. Methods: There were 1406 pre-operative non-weight-bearing CT scans analyzed by a single surgeon experienced with robotically-assisted total knee arthroplasties. These scans were converted into three-dimensional models, focusing on the coronal and sagittal planes. Intraoperatively, the robotic system was used to capture native coronal and sagittal deformities for each patient. These values were captured with the patient's leg held in a non-stress, extension pose. A new classification system, 'The Native Alignment Phenotype', was developed to categorize the specific differences between individual knees. Results: There were four primary knee malalignments identified: varus deformity; valgus deformity; and two deformities in the sagittal plane. These malalignments were further categorized based on the degrees of deviation, creating groups with 5° coronal and sagittal ranges. A total of 77 phenotypic alignment patterns were found based on the analyzed cohort. In the coronal plane, varus HKA deformity between 6 and 10° was the most common, with 36.9% of the cases, followed by varus HKA alignment, which was between 0 and 5°, representing 34.3% of the cases. In the sagittal plane, neutral and flexion contracture deformities between 0 and 5° were the most common, with 32.6% of the cases, followed by a fixed flexion contracture alignment, which was between 6 and 10°, representing 28.7% of the cases. When combining coronal and sagittal planes, the most common alignment was the varus between 0 and 5° with a flexion contracture between 0 and 5° (12.5% of cases), closely followed by the varus between 6 and 10° with a flexion contracture between 6 and 10° (12.4% of cases). Conclusion: The Native Alignment Phenotype classification system offers a nuanced understanding of knee deformities based on three-dimensional (CT scan) assessments, potentially leading to improved surgical outcomes in TKA. By leveraging the detailed data from the CT scans, this system provides a more comprehensive view of the knee's anatomy, emphasizing the importance of individualized, data-driven approaches in knee surgery.

Functional knee phenotypes appear to be more suitable for the Chinese OA population compared with CPAK classification: A study based on 3D CT reconstruction models

Gender, BMI, and Age‐Related Variations in Lower Limb Alignment Parameters and CPAK Phenotypes in Chinese Patients with Knee Osteoarthritis

Distribution of coronal plane alignment of the knee classification in Chinese osteoarthritic and healthy population: a retrospective cross-sectional observational study

Osteoarthritic and non-osteoarthritic patients show comparable coronal knee joint line orientations in a cross-sectional study based on 3D reconstructed CT images

The Posterolateral Corner-Locked Technique is Applicable in a Chinese Population Regarding the Tibial Component Rotation Alignment in Total Knee Arthroplasty.

Measurement of femoral posterior condylar offset and posterior tibial slope in normal knees based on 3D reconstruction

Patient sex and race are associated with differences in coronal plane alignment classification in native arthritic knees

Variability of three-dimensional knee morphology cannot be effectively assessed using a coronal plane knee alignment classification in total knee arthroplasty patients

Radiological Assessment of Coronal Plane Alignment of the Knee Phenotypes in the Romanian Population

Functional knee phenotypes: a novel classification for phenotyping the coronal lower limb alignment based on the native alignment in young non-osteoarthritic patients

Three-dimensional-based native alignment phenotype classification system: Description for use in planning for deformities during total knee arthroplasty

Functional knee phenotypes: A helpful classification tool for visualizing potential femoral varus in restricted kinematic alignment total knee arthroplasty in Japan

Pre- and postoperative Coronal Plane Alignment of the Knee classification and its impact on clinical outcomes in total knee arthroplasty

Femoral and tibial phenotypes of varus alignment in a Southeast Asian arthritic population: a descriptive study

Preoperative phenotype has no significant impact on the clinical outcomes and long-term survival of mechanically aligned total knee arthroplasty in Asian patients with osteoarthritis

Patterns of Compartment Involvement in End-stage Knee Osteoarthritis in a Chinese Orthopedic Center: Implications for Implant Choice

Inverse kinematic alignment accommodates native coronal knee alignment better in comparison to adjusted mechanical alignment and restricted kinematic alignment

Coronal Plane Alignment Classification of Arthritic Knees in a South Indian Population and Functional Outcome Comparison Post-mechanical Alignment Total Knee Arthroplasty

Evaluating axial alignment and knee phenotypes in a young Indian population, using X-rays converted to three-dimensional bone models, and their relevance in total knee arthroplasty

Gender‐based differences exist in the functional knee phenotypes classification of the osteoarthritic knee

Accuracy and outcome of a handheld accelerometer-based navigation device compared to conventional alignment method in total knee arthroplasty in a Chinese population