Abstract:Cavitation of centrifugal blood pump is a serious problem accompany with the blocking failure of short inlet cannula. However, hardly any work has been seen in published literature on this complex cavitation phenomenon caused by the coupling effect of inlet cannula blocking and pumps suction. Even for cavitation studies on ordinary centrifugal pumps, similar researches on this issue are rare. In this paper, the roles of throttling, rotation speed and fluid viscosity on bubble inception and intensity in a centrifugal blood pump are studied, on the basis of experimental observations. An adjustable throttle valve installed just upstream blood pump inlet is used to simulate the throttling effect of the narrowed inlet cannula. The rotation speed is adjusted from 2 600 r/min to 3 200 r/min. Glycerin water solutions are used to investigate the influences of kinetic viscosity. Bubbles are recorded with a high-speed video camera. Direct observation shows that different from cavitation in industrial centrifugal pumps, gas nuclei appears at the nearby of vane leading edges while throttling is light, then moves upstream to the joint position of inlet pipe and pump with the closing of the valve. It's found that the critical inlet pressure, obtained when bubbles are first observed, decreases linearly with viscosity and the slope is independent with rotation speeds; the critical inlet pressure and the inlet extreme pressure which is obtained when the throttle valve is nearly closed, fall linearly with rotation speed respectively and the relative pressure between them is independent with rotation speed and fluid viscosity. This paper studies experimentally on cavitation in centrifugal blood pump that caused by the failure of assembled short inlet cannula, which may beneficial the design of centrifugal blood pump with inlet cannula.

Investigation on the effects of blade thickness for a centrifugal rotary blood pump

Blade Thickness Redesign to Improve Efficiency and Decrease Unsteady Pressure Pulsation of a Low Specific Speed Centrifugal Pump

[Numerical study of the effect of geometrical parameters of straight impellers on the flow and hemolysis performance of centrifugal blood pumps]

Hydraulic Optimization and Loss Analyses of a Low Specific-Speed Centrifugal Pump with Variable-Thickness Blades

Blade Redesign Based on Secondary Flow Suppression to Improve Energy Efficiency of a Centrifugal Pump

Optimizing the design of axial flow pump blades based on fluid characteristics

Development of a centrifugal pump with thick blades

Optimization of a Centrifugal Impeller on Blade Thickness Distribution to Reduce Hydro-Induced Vibration

Experimental Study of Cavitation Phenomenon in A Centrifugal Blood Pump Induced by the Failure of Inlet Cannula

Design Improvement for Interventional Blood Pumps Based on Flow Analysis

Influence of rotor impeller structure on performance improvement of suspended axial flow blood pumps

Effects of blade number and thickness on performance of mixed-flow pumps

Design Optimization Of Flow Channel And Performance Analysis For A New-Type Centrifugal Blood Pump

Experimental Investigation and Numerical Simulation of the Hydraulic Performance of a Centrifugal Blood Pump

Numerical Investigation of Influence of Rotor-Rotor Gap on Performances of Contra-Rotating Axial Flow Pump

Research on the effects of different blade leading-edge geometries on the internal and external characteristics of centrifugal pumps

Computational fluid dynamics analysis of blade tip clearances on hemodynamic performance and blood damage in a centrifugal ventricular assist device

Numerical Simulation and Experimental Research on Passive Hydrodynamic Bearing in a Blood Pump

Effect of blade thickness on rotating stall of mixed-flow pump using entropy generation analysis

Investigation of hemocompatibility and vortical structures for a centrifugal blood pump based on large eddy simulation

On the Optimization of a Centrifugal Maglev Blood Pump Through Design Variations