Abstract:The unloading and reloading of geostress during the excavation of large underground caverns tends to bring about large deformation and failure problems of rock masses with interlayer staggered zones (ISZs), posing significant threats to the safety and stability of the underground cavern. Hence, for interlayer staggered zones with complex mechanical response behaviors, a series of conventional triaxial cyclic loading tests under different confining pressures were carried out. It can be seen from these results that the envelop curves of stress–strain relations were of obvious memory, but the peak deviator stress, internal friction angle, and cohesion were lower than those in monotonic loading. The phenomenon of volume expansion occurred in the whole process of cyclic loading and unloading, and the unloading dilatation seemed to be more sensitive to relatively low confining pressure. The volume expansion reached its highest value when the unloading stress level (i.e., the ratio of the stress ratio in the process of the cyclic test to the stress ratio when the ISZ comes to the failure point) increased to more or less 0.6∼0.8. Moreover, the changing trend of the average rebound modulus was humplike with the increase of unloading stress level, and the ratio of average rebound modulus to monotonic initial elastic modulus declined as a power function. Additionally, the validity of the unloading rebound modulus calculation by the Duncan-Chang model is proved. The analysis of energy consumption in plastic hysteresis loops indicates that the plastic hysteresis energy of the specimen in each cycle rose with the stress level’s increase. Further microscopic failure mechanism analysis shows that the previous research results are synthetically affected by factors including particle motion and breakage, initiation and propagation of original and new fractures, yield, and damage of interlayer staggered zones. This research provides a theoretical premise for exploring the cyclic unloading and reloading stress path influence on the failure of surrounding rock with ISZs, as well as for more reasonable mechanical parameter selection in deep underground excavations.

Strength Reduction of Initial High-Stress Rock Pillars Under Different Triaxial Unloading Paths

Experimental investigation on pillar rockburst of true triaxial four-face rapid unloading under high stress

Failure Characteristics of Granite Influenced by Sample Height-to-Width Ratios and Intermediate Principal Stress Under True-Triaxial Unloading Conditions

An Experimental Investigation on the Foliation Strike-Angle Effect of Layered Hard Rock under Engineering Triaxial Stress Path

Numerical simulation of true triaxial unilateral unloading effect of fractured rock

Evaluation of energy storage and release potentials of highly stressed rock pillar from rockburst control perspectives

Experimental Study of the Triaxial Strength Properties of Hollow Cylindrical Granite Specimens under Coupled External and Internal Confining Stresses

Particle Flow Simulation of Failure Characteristics of Deep Rock Influenced by Sample Height-to-Width Ratios and Initial Stress Level under True-Triaxial Unloading

Numerical Study of Failure Mechanism of Serial and Parallel Rock Pillars

Experimental study on the influence of intermediate principal stress on failure characteristics of strain rock burst for granite

Experimental and simulation investigation on failure characteristic of granite considering the effect of intermediate principal stresses

Mechanical behaviour and instability mechanism of sandstones with impact tendency under different loading paths

Load Transfer Behavior During Cascading Pillar Failure: An Experimental Study

Failure Behaviors of Granitic Rocks Induced by Point/local Loads under Biaxial Compression Stress State

Experimental Study on Rock Strength and Deformation Characteristics Under Triaxial Cyclic Loading and Unloading Conditions

Mechanical properties and stability analysis of surrounding rock of underground cavern under various stress loading paths

Mechanical Response and Failure Characteristics of Granite under Unloading Conditions and Its Engineering Application

Experimental Study on the Strength Failure Characteristics of Columnar Jointed Rock Masses under Three-Dimensional Stress

Experimental Study of Mechanical Behavior of Interlayer Staggered Zone under Cyclic Loading and Unloading Condition

Deformation and mechanical properties of rock: effect of hydromechanical coupling under unloading conditions

Three-dimensional Discrete Element Simulation on Mechanical Response and Failure Characteristics of Composite Rock under Triaxial Unloading Condition