Abstract:Journal of Composite Materials, Ahead of Print. Thermoplastic composite materials are being increasingly used in many domains, such as automotive, marine and aeronautics. This growing interest is due to the relatively good mechanical properties and the recycle-ability of these materials. In various heat assisted forming technologies, thermoplastic composites may be subjected to severe conditions such as high temperatures, complex strain paths and potentially significant strain rates. This is expected to highly influence the overall behavior of these materials and make the characterization of their mechanical behavior more complicated. In this paper, the mechanical behavior of discontinuous glass fiber reinforced polypropylene composite is investigated at temperatures going from room temperature (RT) to 120°C and strain rates ranging from quasi-static conditions to 10 s−1 by means of uniaxial tensile tests. The effect of material orientation is also investigated at RT and quasi-static strain rate of 0.001 s−1 pointing out a clear anisotropic behavior. The tensile properties including Young's modulus E, ultimate tensile strength σult and strain at failure ɛf are determined based on the Standard ISO-527 reporting an obvious sensitivity of the material to temperature and strain rate. Based on literature review, the phenomenological isotropic constitutive model of G'Sell and Jonas, originally designed for unreinforced semi-crystalline polymers, is selected to describe the mechanical behavior of the studied material. A modification of the original constitutive equation is proposed for a better representation of the overall behavior of the material at different temperature and strain rate conditions. Finally, the validity of this phenomenological law calibrated by means of the uniaxial tests, is evaluated for an equi-biaxial loading state close to that encountered by the material during heat assisted sheet forming process. The significant disagreement highlighted between numerical and experimental results proved that the uniaxial tensile tests are not sufficient to characterize the behavior of the material when a complex loading condition is imposed.

Investigation of the spring-back phenomenon in two-dimensional bending of continuous glass fiber-reinforced polyamide composite sheets

Spring-in behavior of woven carbon fiber/polycarbonate thermoplastic composites

Multi-scale finite element analysis of laser-assisted forming of CF/PEEK composite corner structures

Large Deformation Bending of Single‐ply Fabric Reinforced Polymer Composite

Experimental Characterisation of Cure-Dependent Spring-Back Behaviour of Metal-Composite Laminates in a Hot-Pressing Process

Unconstrained bending and springback behaviors of aluminum-polymer sandwich sheets

Investigations of three-dimensional fiber orientation on mechanical impact behavior of short glass-fiber-reinforced PEEK composites

Biaxial fatigue failure of short glass fiber reinforced polyamide 6,6: An in-depth investigation of stiffness drop and microstructural evolution

Permanent Deformation and Stiffness Degradation of Open Hole Glass/PA6 UD Thermoplastic Composite in Tension and Compression

Influence of intra-ply discontinuities on the mechanical behavior of continuous E-glass fiber reinforced composites

Experimental study of the importance of fibre breakage on the strength of thermoplastic matrix composites subjected to compression after impact

Investigation on V-Bending and Springback of Laminated Steel Sheets

Assessing pseudo-ductile behavior of woven thermoplastic composites under tension and bending

Biaxial Yield Surface Investigation of Polymer-Matrix Composites

Experimental Determination of Fracture Toughness of Woven/Chopped Glass Fiber Hybrid Reinforced Thermoplastic Composite Laminates

Investigation on the Bending Properties and Geometric Defects of Steel/Polymer/Steel Sheets—Three-Point and Hat-Shaped Bending

Static behavior of thick flax/epoxy composite laminates: multi-instrumentation mechanical failure analysis

Direct Testing of Gradual PostPeak Softening of Notched Specimens of Fiber Composites Stabilized by Enhanced Stiffness and Mass

Concave and convex small radius bending behavior of single and multiple layers reinforcement fabrics

Physical analysis and statistical investigation of tensile and fatigue behaviors of glass fiber-reinforced polyester via novel fibers arrangement

Thermo-visco mechanical behavior of glass fiber reinforced thermoplastic composite