Abstract:In the present research, the Al-Si-Fe hypereutectic alloys with different Ti addition were prepared and the electric field treatment was performed on the alloys to regulate the phase morphology. The microstructure and mechanical properties of the alloys were characterized by OM, SEM, TEM, EPMA and tensile test. The results reveal that the Al-Si-Fe hypereutectic alloy prepared by conventional casting is mainly composed cubic β-Si phase, long rod-like and needle-like β-Al 5 FeSi phases. In addition, there are stacking faults in the β-Al 5 FeSi phase. Minor Ti addition in Al-Si-Fe hypereutectic alloy could change the needle-like phase into eutectic structure, decrease the size of β-Al 5 FeSi phase and homogenize the β-Si phase size. The more Ti addition tends to coarsen the β-Al 5 FeSi and β-Si phases, and moreover the needle-like phase precipitate again. The electric field treatment promotes the coarsening of β-Al 5 FeSi and β-Si phases in the Al-Si-Fe hypereutectic alloy with 0-1.0 wt.% Ti addition, but results in the refinement of β-Al 5 FeSi and β-Si phases in 1.5 wt.% Ti doped Al-Si-Fe hypereutectic alloy. Furthermore, the needle-like phase has been transformed into small-size eutectic structure in the 1.0 and 1.5 wt.% Ti doped Al-Si-Fe hypereutectic alloys. With the synergistical effect of Ti addition and electric field treatment, the 1.5 wt.% Ti doped Al-Si-Fe hypereutectic alloy obtains yield strength of 100 MPa and ultimate tensile strength of 113 MPa, which is about 26% and 37% higher than the conventional-cast Al-Si-Fe hypereutectic alloy.

Microstructure Evolution and Thermophysical Properties of Hypereutectic Al-Fe-Ni Alloys

Experimental and theoretical study of the microstructure evolution and thermal-physical properties of hypereutectic Al–Fe alloys

Regulating microstructures and mechanical properties of Al-Fe-Ni alloys

Preparation and properties of FeNiMnCuC0.2Alx high-entropy alloy

Regulation on Microstructures and Properties of Hypereutectic Al–3.5Fe–2.5Ni Alloy by Controlled Diffusion Solidification

Thermal stability of Al–Fe–Ni alloy at high temperatures

Effect of Fe Addition on Microstructure and Properties of Al-3ni Alloys

Multi-component Phase-Field Simulation of Microstructural Evolution and Elemental Distribution in Fe–Cu–Mn–Ni–Al Alloy

Microstructures and Mechanical Behaviors of NiAlFe Intermetallic Compounds

Microstructure and solidification behaviour of Ni3Al/Ni7Hf2 eutectic alloy

Microstructure and mechanical properties variation with Ni content in Al0.8CoCr0.6Fe0.7Nix (x = 1.1, 1.5, 1.8, 2.0) eutectic high-entropy alloy system

Solidification and microstructure investigation on as-cast and annealed hypoeutectic Ti–Fe alloys

The composite microstructures’ effect on the mechanical properties of Ni–25Al–xFe intermetallics

Microstructure and properties of a novel cost-effective FeNi-based eutectic high entropy alloys

Microstructure Evolution of Directionally Solidified Al-12%Ni Hypereutectic Alloy

Effect of Ti Addition and Electric Field on Microstructure and Mechanical Properties of the Al-Si-Fe Hypereutectic Alloy

Effect of Ni addition on the microstructure, conductivities and mechanical properties of as-cast Al-Fe alloys

Effect of Fe content on microstructures and mechanical properties of eutectic Co-Cr-Fe-Ni-Hf multi-principal element alloys

Effects of Al Addition on Structural Evolution and Tensile Properties of the FeCoNiCrMn High-Entropy Alloy System

The Evolution of Microstructure and Mechanical Properties at Elevated Temperature of Cast Al–Li–Cu–Mg Alloys with Ni Addition

Electrothermal, magnetic properties and microstructure of CrFeNiTi<i> <sub>x</sub> </i> compositionally complex alloys