Abstract:The influence of the preparation methods of the nanosized ZrO2-based catalysts and the addition of Al2O3 and KOH promoters to ZrO2 on their catalytic properties for the direct synthesis of isobutene from CO hydrogenation was investigated. The results indicate that the physical properties and the catalytic performance of the nanosized ZrO2 are strongly influenced by the preparation methods. The ZrO2 catalyst that is dried by the supercritical fluid drying method then calcined in a flow of N-2 is the most selective to isobutene. Al2O3 and KOH show excellent promoting effects on ZrO2 and can remarkably enhance the i-C-4 selectivity (65.2%) in the total hydrocarbons, while surely maintaining the CO conversion at 20.9%, which is more than that over the pure ZrO2(18.9%). The acidic and basic properties of the Al2O3 and KOH promoted ZrO2-based catalysts were characterized by NH3-TPD and CO2-TPD. The results indicate that the catalyst performance depends strongly on the acid-base properties of the catalysts. Increasing the amounts of acid sites on ZrO2 can enhance the activity and promote the formation of linear C-4 hydrocarbons. However, the amounts of base sites are very important for the formation of i-C-4 hydrocarbons. With the increasing of the ratio of base sites to acid sites on the catalysts, the percentage of i-C-4 in the total C-4 hydrocarbons increases. A certain amount of Al2O3 and KOH added to ZrO2 enhances both the amount of acid and base sites on ZrO2, while maintaining an appropriate ratio of base sites to acid sites.

Optimization of Conditions for the Synthesis of 4,4-Dimethyl-1,3-dioxane from tert-Butanol in the Presence of Carbon-Сontaining Porous Materials

Synthesis of Isophorone Diamine and its Reaction Condition Optimization

Evaluation of Strongly Acidic Ion-Exchange Catalysts and the Desulfonation Study in the Isobutylene Dimerization Reaction

An Improved Synthesis of 2,2-Diethoxypropane by Using Triethyl Orthofomate

New Synthesis Process of 2,7-Dimethyl-2,4,6-octatriene-1,8-dial

Selective peroxidation of isobutane with molecular oxygen over molybdenum oxide catalyst for direct synthesis of di-tert-butyl peroxide

Synthesis of 2,4-Diisopropyl-5,5-dimethyl-1,3-dioxane Catalyzed by Brønsted Acidic Ionic Liquids

Highly efficient and selective synthesis of renewable isoprene over Mo‐Fe‐O and MgO/Mg(OH)2 composite catalysts

Synthesis of Green Oxane and 1,3-Dioxolanes Catalyzed by Copper p-Toluene Sulfonate

Selective Production of Toluene from Biomass-Derived Isoprene and Acrolein.

Synthesis of 1,3-Diols from Isobutene and HCHO via Prins Condensation-Hydrolysis Using CeO2 Catalysts: Effects of Crystal Plane and Oxygen Vacancy

Fischer-Tropsch Synthesis of C4-C5 Isoparaffins Via Cox Mn1-x O Nanocomposites with Suppressed CO2

Fischer-Tropsch Synthesis of C4-C5 Isoparaffins via CoxMn1- xO Nanocomposites with Suppressed CO2

Highly Efficient Dimerization of Isopentene Catalyzed by MCM-41 Supported Phosphotungstic Acid

Synthesis of iso-C4 hydrocarbons from CO hydrogenation over Pr6O11 and Pr-Zr-O composite oxide catalysts

Investigation of the Selective Sites on Graphitic Carbons for Oxidative Dehydrogenation of Isobutane

Study on Technological Conditions of Transesterification Reaction of Synthesis of Tetrakis [3-(3,5-di-tert-butyl-4-hydroxyphenyl) propionyloxymethyl] methane

Synthesis of isobutene from CO hydrogenation over nanosized zirconium dioxide-based catalysts

A novel tandem route to renewable isoprene over Mo-Fe oxide and mesoporous Cu/MgO composite catalysts

Design and optimization of a catalytic membrane reactor for the direct synthesis of propylene oxide

Sorption enhanced carbon dioxide hydrogenation to methanol: Process design and optimization