Synthesis of isobutene from CO hydrogenation over nanosized zirconium dioxide-based catalysts

Yingwei Li,Dehua He,YuBin Yuan,ZhenXing Cheng,QiMing Zhu
DOI: https://doi.org/10.3321/j.issn:0253-9837.2002.02.025
IF: 16.5
2002-01-01
Chinese Journal of Catalysis
Abstract:The influence of the preparation methods of the nanosized ZrO2-based catalysts and the addition of Al2O3 and KOH promoters to ZrO2 on their catalytic properties for the direct synthesis of isobutene from CO hydrogenation was investigated. The results indicate that the physical properties and the catalytic performance of the nanosized ZrO2 are strongly influenced by the preparation methods. The ZrO2 catalyst that is dried by the supercritical fluid drying method then calcined in a flow of N-2 is the most selective to isobutene. Al2O3 and KOH show excellent promoting effects on ZrO2 and can remarkably enhance the i-C-4 selectivity (65.2%) in the total hydrocarbons, while surely maintaining the CO conversion at 20.9%, which is more than that over the pure ZrO2(18.9%). The acidic and basic properties of the Al2O3 and KOH promoted ZrO2-based catalysts were characterized by NH3-TPD and CO2-TPD. The results indicate that the catalyst performance depends strongly on the acid-base properties of the catalysts. Increasing the amounts of acid sites on ZrO2 can enhance the activity and promote the formation of linear C-4 hydrocarbons. However, the amounts of base sites are very important for the formation of i-C-4 hydrocarbons. With the increasing of the ratio of base sites to acid sites on the catalysts, the percentage of i-C-4 in the total C-4 hydrocarbons increases. A certain amount of Al2O3 and KOH added to ZrO2 enhances both the amount of acid and base sites on ZrO2, while maintaining an appropriate ratio of base sites to acid sites.
What problem does this paper attempt to address?