Abstract:In this study, to solve the problem of reducing the quantity and increasing the utilization of waste as resource for high silica tailings (HSTs) after extracting alumina from high alumina coal ash, lightweight thermal insulation materials for building were prepared by using the melt foaming method. The effects of the calcination temperature and holding time on the melting characteristics of ingredients with different melt indexes were investigated. The effects of the amount of foaming agent on the bulk density, total porosity, and thermal conductivity of porous ceramics were determined, and the thermal conductivity model structure was further elucidated by comparing the experimental data with the values predicted by a theoretical model. The results showed that porous ceramics with optimal performance were prepared by calcination at 1200 °C for 30–60 min with a melt index of 8k, and the amount of added SiC foaming agent was 0.52 wt%. The bulk density, total porosity and thermal conductivity were determined for the prepared porous ceramics as 0.196 g cm −3 , 93.8%, and 0.086 W m −1 K −1 , respectively, where the added amount of HSTs reached 60 wt%. Comparison and verification of the thermal conductivity model confirmed that the prepared mullite based porous ceramics should be classified as materials with internal porosity, where the pores were dispersed in the mullite continuous phase to form isolated closed pores. The results obtained in this study are of economic significance for the reuse of HSTs at large dosages and with high added value.

Lightweight porous silica-alumina ceramics with ultra-low thermal conductivity

Anisotropic Porous Ceramic Material with Hierarchical Architecture for Thermal Insulation

Thermal Conductivity of Silica-aerogel (SA) and Autoclave Aerated Concrete (AAC) Composites

Porous anorthite ceramics with ultra-low thermal conductivity

Fabrication of SiCN(O) Aerogel Composites with Low Thermal Conductivity by Wrapping Mesoporous Aerogel Structures over Mullite Fibers

Porous mullite ceramics with enhanced compressive strength from fly ash-based ceramic microspheres: Facile synthesis, structure, and performance

High temperature ceramic thermal insulation material

Facile Method for Preparing Hierarchical Al2O3-Glass Foam Ceramics with Superior Thermal Insulating Property.

Highly compressible and anisotropic lamellar ceramic sponges with superior thermal insulation and acoustic absorption performances

Foam-gelcasting preparation of porous SiC ceramic for high-temperature thermal insulation and infrared stealth

Highly Porous Zirconia Ceramic Foams with Low Thermal Conductivity from Particle‐Stabilized Foams

Experimental and numerical research on high‐temperature thermal insulation performance of lightweight porous ceramic/nanomaterial composite structure

Lightweight, Strong, and Super-Thermal Insulating Polyimide Composite Aerogels under High Temperature

Nanoengineering Porous Silica for Thermal Management

Novel silica-modified boehmite aerogels and fiber-reinforced insulation composites with ultra-high thermal stability and low thermal conductivity

Fabrication of foamed ceramics with enhanced compressive strength and low thermal conductivity via a simple route

Facile Method for Preparing Hierarchical Al 2 O 3 –Glass Foam Ceramics with Superior Thermal Insulating Property

Light and strong nano-SiC foam with extremely low thermal conductivity

High-strength porous alumina ceramics prepared from stable wet foams

Fabrication of the SiC/HfC Composite Aerogel with Ultra-Low Thermal Conductivity and Excellent Compressive Strength

Thermal properties of mullite based porous ceramics derived from high silica tailings obtained after extracting alumina from high alumina coal ash