Abstract:Sulfur compounds in coal gas must be removed before gas processing or burning to meet the chemical synthesis and environmental law. The developments of desulfurization sorbent and technologies at high temperature have been attracting world wide attention because of its importance to the advanced coal based power generation (e.g. IGCC). The existing problems for coal gas desulfurization technology at high temperature are the loss of effective component and the powdering of desulfurizer which considerably hinder the industrial application. Zinc titanate desulfurizer is regarded as a promising sorbent for its good chemical and mechanical performance. The effect of the concentration of H_2S and desulfurization temperature on the desulfurization beheavior of zinc titanate (Zn_2TiO_4)sorbent and the kinetic model validation were investigated in a fixed bed reactor under atmospheric pressure. The results show that the sorbent has a very good desulfurization performance. The desulfuization rate of the sorbent increases with raising the sulfidation temperature in the range of 400 ℃ ～600 ℃ and the H_2S concentration of inlet gas in the range of 3 g/m3～10 g/m3. Model tests show that the desulfurization process can be fitted by the equivalent grain model with the diffusion controlling in the product layer. The calculated values of diffusion activation energy and corresponding frequency factor are 61.4 kJ/mol and 4.4×10 -5 m2/min, respectively. It suggests that the desulfurization process is controlled by solid grain diffusion instead of pore diffusion. It is found that specific surface area and pore volume of the sulfided sample decrease considerably and there are many congregating grains formed on the surface of sulfided sorbent by means of N_2 adsorption analysis and SEM photos of surface morphology, which further validates that the desulfurization of Zn_2TiO_4 sorbent is controlled by the solid grain diffusion.

Kinetic and Thermodynamic Study of the Wet Desulfurization Reaction of ZnO Sorbents at High Temperatures

Deactivation Model Study of High Temperature H2S Wet-Desulfurization by Using ZnO

Microwave-assisted Synthesis of Zn-Fe Adsorbent Supported on Alumina: Effect of Zn to Fe Ratio on Syngas Desulfurization Performance

Performance Evaluation of Zn-Fe Adsorbent for H 2 S Adsorption During Biogas Purification

Review of high temperature H2S removal from syngas: Perspectives on downstream process integration

Experimental Bench-Scale Study of Residual Biomass Syngas Desulfurization Using ZnO-Based Adsorbents

Microkinetics of H 2 S Removal by Zinc Oxide in the Presence of Moist Gas Atmosphere

Warm Cleanup of Coal-Derived Syngas: Multicontaminant Removal Process Demonstration

Dynamic Desulfurization Process over Porous Zn–Cu-Based Materials in a Packed Column: Adsorption Kinetics and Breakthrough Modeling

A Study on the Apparent Kinetics of H2S Removal Using a ZnO−MnO Desulfurizer

Kinetics of Zinc Titanate Desulfurization at High Temperature

Kinetic Study on High-Temperature H2S Removal over Mn-Based Regenerable Sorbent Using Deactivation Model

Modeling of Hydrogen Sulfide Removal Using Zinc Oxide Desulfurizer

Kinetic Study on the Sulfidation and Regeneration of Manganese-Based Regenerable Sorbent for High Temperature H2S Removal

Study on the Stability of Sorbents Removing H2S from Hot Coal Gas

Experimental Study on Desulfurization Performance of Hot Gas at Medium and High Temperature

Use of high-pressure impregnation in preparing Zn-based sorbents for deep desulfurization of hot coal gas

Design and Performance of an Adsorption Bed with Activated Carbons for Biogas Purification

Models of high-temperature desulfurization using zinc-based sorbents

High-Temperature Syngas Desulfurization and Particulate Filtration by ZnO/Ceramic Filters

Regenerable Co-ZnO-based Nanocomposites for High-Temperature Syngas Desulfurization