Abstract:Much of surplus ammunition stockpile inevitably requires demilitarized processing technology in the explosives industry. For the safe waste treatment and recycle, the thermoplastic polymer bonded explosive (PBX) can effectively reduce the military cost and non-conforming products. In addition, the thermoplastic PBX has excellent application prospect as the future explosive due to the good mechanical properties and insensitivity. However, for high solid content, most of thermoplastic PBXs still maintain a considerable viscosity even in high-temperature melting state, rendering traditional casting process unsuitable. In this study, a measuring method was adopted to accurately obtain the correlation of Pressure-Volume-Temperature (PVT) for the simulative materials of thermoplastic PBX at first. The equations of state for PVT and viscosity model were then created, which are of great significance in single screw extrusion. An experiment system of single screw extrusion was designed to implement the molding process considering the poor liquidity problem of the thermoplastic materials. Excellent molding stability (rho<0.5 % variation) was achieved for the extrusion system. Moreover, a numerical investigation was also performed. Good agreements were yielded by comparing the simulation data and experimental results. The effects of operational parameters, i. e., the entrance pressure, barrel temperature and rotation speed on molding process of the thermoplastic materials were investigated in detail. The wall shear stress decreases with the feed inlet well sealed whereas the maximum temperature rise increases a little due to limited thermal diffusion. Either increasing temperature or decreasing rotation speed is beneficial to overall process safety. However, production cycle and attainable molding density also need to be considered at the same time. Furthermore, the process parameters should be optimized on the basis of the PVT and viscosity properties of material in practice. The investigations above can be a better guidance for the development and implementation of thermoplastic PBXs molding process.

The Mechanism of Quasi-Dynamic Expansion Method and the Design of the Equipment for Manufacturing Biaxial Oriented PVC Pipes

Design of a Large Diameter Steel Reinforced Plastic Pipe

Short-Term Mechanical Analysis of Polyethylene Pipe Reinforced by Winding Steel Wires Using Steel Wire Spiral Structural Finite Element Model

Design and Experiments of an Automatic Pipe Winding Machine

Study on the pneumatic conveying pipe connection joint design and mechanical properties

The Hydroforming Process with Radial Self-energizing Seal for Manufacturing Bimetal-lined Pipe

The bearing capacity performance of upvc pipe under axial compression

Combined Processing of Polypropylene Film by Coextrusion and Zone‐annealing

Arranging the Plastic Hinges and Improving the Strength of Steel Tubes with Tapered Ends: Analysis and Tests

Biaxial reinforcements for polyethylene medical-tubes via helical convergent flow

Rigid PVC with Low Foaming Extruding Technique

Experimental Investigation on Mechanical Properties of Plastics Pipes Reinforced by Cross-winding Steel Wire

3D Pipe Forming of a New Bending Machine with a 3PUU–3RPS Hybrid Mechanism

A Novel One-Step Reactive Extrusion Process for High-Performance Rigid Crosslinked PVC Composite Fabrication Using Triazine Crosslinking Agent@Melamine-Formaldehyde Microcapsules

Enhanced effect of thermal expansion process in rotational shear technology for high performance HDPE pipes

Research and design of proper packing machine of PVA water-soluble film

Experimental and Numerical Analysis of Single Screw Extrusion Process for Thermoplastic PBX Based on PVT Properties

Analysis On The Mechanical Properties Of The Plastic Pipe Reinforced By Cross Helically Winding Steel Wires(Psp) Under Internal Pressure

Analyses on the Short-Term Mechanical Properties of Plastic Pipe Reinforced by Cross Helically Wound Steel Wires

Study on Hydro-Forming Technology of Manufacturing Bimetallic CRA-lined Pipe

A New Bionic Elastic Mandrel for Application in the Spatial Consecutive RDB with no Straight Line