Abstract:A graphical abstract of this paper. With the rapid development of transportation and electronic equipment industries, lightweight requires reliable joining technology for metal/polymer. Preheating before welding is a potential way to improve the tensile properties of the joint and reduce the risk of defect formation. In this study, thermal assistance friction stir lap welding (TA‐FSLW) in joining 6061‐T6 aluminum alloy and carbon‐fiber‐reinforced thermoplastic (CFRTP) is investigated. The welds are evaluated by OM image segmentation and statistical calculation, temperature detection in thermal imaging, SEM and EDS of the fracture, tensile, and hardness analysis. From the quantitative analysis results of the width of the CFRTP side‐melting zone and the area of Al alloy fragments in the welding zone, the movement of the polymer chain in the CFRTP of joint is intensified by thermal assistance, which reduces the thickness of the melting zone on the side of the composite material. The area of metal fragments ranges from 100 to 2 × 106 μm2. The microscopic analysis results indicate that preheating enhances the initial thermal motion of molecules. Gaseous polymers are dissociated from the molten state, reducing the number of bubbles in the composite material. Small size fragments are inserted into the molten CFRTP and mechanical interlocking is enhanced due to the uniform interweaving of metals and polymers. A maximum tensile strength of 39.97 MPa is achieved, which increases by 37.6% compared with the conventional FSLW. Highlights Thermal assistance friction stir welding technology is applied to the welding of aluminum alloy with carbon‐fiber‐reinforced thermoplastic. The number and area of aluminum alloy fragments are counted and analyzed by the metal segmentation counting algorithms. Thermal assisted technology reduces the thickness of the melting zone of CFRTP and enhances the material flow and refinement of aluminum alloy fragments.

A new method for joining of polymer sheet and open-cell metal foam by thermal assisted incremental forming

Pore form and size dependence on plastic joining characteristics of resin/metallic foam by friction stir incremental forming

Preparation, Characterization and Designing of Porous Ti–6Al–4V Through Metal Injection Molding Without Space Holder

Interfacial Bonding During Multi-Material Fused Deposition Modeling (FDM) Process Due to Inter-Molecular Diffusion

Study on the thermal assistance friction stir lap welding of aluminum alloy and CFRTP

Experimental and numerical studies on two-point incremental forming of woven fabric composite sheet

Fabricating sandwich composite tubes using a new thermal expansion technique: Materials preparation and energy absorption characteristics

Interface structure and bonding strength of metallurgical bonded aluminum foam sandwich (AFS) fabricated by hot-pressing

Microstructural characteristics and mechanical properties of 7075 aluminum alloy foam sandwich panels fabricated via integrated forming and foaming

Achieving high strength friction lap spot joints of carbon fiber reinforced thermosetting composite to aluminum alloy with additional thermoplastic interlayer

Experimental and numerical study of thermoforming of Al/CFRP hybrid composites

Heat-assisted friction stir incremental sheet forming of thermoplastics

Integrating interfacial bonding and coordinated deformation in steel/Al bilayers via a pin-less friction stir-assisted synchronous joining-forming approach

Change in geometry size and thinning rate in single-point incremental forming process of TA1 sheet: evaluation method and finite element analysis

Influence of metal surface structures on composite formation during polymer‐metal‐joining based on reactive Al/Ni multilayer foil

Development and Analysis of a New Joining Method for Polymer-Metal Hybrid Structures

Hybrid Laser Technique for Joining of Polymer and Titanium Alloy

Hybrid joining process for carbon fiber reinforced thermosetting plastic and metallic thin sheets by chemical bonding and plastic deformation

Improving bonding strength of Al/CFRTP hybrid joint through modifying friction spot joining tools

Research on joint strength and energy absorption of CFRP and Al sheets bonded-FDS hybrid joining

Optimization of Friction Lap Joining Parameters and Exploration Connection Mechanism of CFRPA6/6061-T6 Aluminum Alloy Hybrid Structures