Abstract:Lightweight, carbon fibre reinforced composites are often employed for the manufacture of aerospace components due to their good strength to weight ratio. However, due to poor interlaminar strength, composite components are prone to barely visible impact damage, caused by low velocity impacts, during aircraft operation. Guided-wave-based structural health monitoring (SHM) techniques, using a network of distributed sensors, is an important Structural Health Monitoring (SHM) tool for the detection and localization of in-service impact damage in composite structures. However, the material anisotropy of composite laminates influences guided wave propagation and scattering. These anisotropic effects, if unaccounted for, could lead to inaccurate localization of damage, and potential regions of the structure where guided waves cannot propagate with sufficient amplitude, reducing damage sensitivity. Defect characterization can be improved by considering the scattering characteristics of various damage types for the sparse array signal processing. Guided wave scattering (A0 Lamb wave mode) was investigated around an artificial insert delamination in a quasi-isotropic CFRP panel. Permanent magnets, mounted on an undamaged region of the plate, were also used as scattering targets and compared to the delamination case. Full 3D Finite Element (FE) simulations were performed for both the delamination and magnet cases and compared to wavefield data obtained from non-contact laser Doppler vibrometer (LDV) measurements. Individual ply layers were modelled using unidirectional composite material properties to accurately capture the anisotropy effects. Good agreement was found between the experimental measurements and simulations. Scattered guided wave amplitudes around each damage type show strong directional dependency with energy focusing along the fiber directions of the outer ply layers of the laminate. Distinct scattering behavior was observed for each damage type. Implications of anisotropy and angular scattering on sparse array SHM of different defect types are discussed.

Defect Detection and Imaging in Composite Structures Using Magnetostrictive Patch Transducers

Inspection of defects in composite structures using long pulse thermography and shearography

Guided Ultrasonic Wave Monitoring of Damage in Anisotropic Composites

Defect identification in thick porous and wavy composites with hybrid use of ultrasound non-reciprocity and scattering

Defect imaging in carbon fiber composites by acoustic shearography

Nondestructive Testing of Thin Composite Structures for Subsurface Defects Detection Using Dynamic Laser Speckles

SH-wave based defect imaging method for CFRP plates with variable thickness

Detection and characterisation of defects in composite materials using microwave non-destructive testing methods

Vibration-Based In-Situ Detection and Quantification of Delamination in Composite Plates

Nondestructive Detection of Defects in GFRP Laminates by Microwaves

Localization of Defects in Woven-Fabric Type CFRP Plate by Time of Flight of Scattering Guided Wave.

Non-destructive testing of composite plates by holographic vibrometry

Detection of damage in laminated composite structures using transverse shear mode

Photothermal defect imaging in hybrid fiber metal laminates using the virtual wave concept

A novel microwave-based non-destructive testing system for detection of sub-surface defects in natural flax fiber reinforced composite material

Nondestructive Damage Detection of a Magentostricive Composite Structure

Damage Identification in Various Types of Composite Plates Using Guided Waves Excited by a Piezoelectric Transducer and Measured by a Laser Vibrometer

Nondestructive Testing of Defects in Polymer–Matrix Composite Materials for Marine Applications Using Terahertz Waves

Miniaturized multi-modality field-ready sensing system for defect detection of CFRP materials

Identifying Defects in Aerospace Composite Sandwich Panels Using High-Definition Distributed Optical Fibre Sensors

Evaluation of Defect Detection in Aluminium, CFRP and Epoxy Resin Plates Using Non-contact Air-Coupled Ultrasonic Waves