Abstract:Conventional ultrasound inspection has been a standard non-destructive testing method for providing an in-service evaluation and noninvasive means of probing the interior of a structure. In particular, measurement of the propagation characteristics of Lamb waves allows inspection of plates that are typical components in aerospace industry. A rapid, complete non-contact hybrid approach for excitation and detection of Lamb waves is presented and applied for non-destructive evaluation of composites. An air-coupled transducer (ACT) excites ultrasonic waves on the surface of a composite plate, generating different propagating Lamb wave modes and a laser Doppler vibrometer (LDV) is used to measure the out-of-plane velocity of the plate. This technology, based on direct waveform imaging, focuses on measuring dispersive curves for A0 mode in a composite laminate and its anisotropy. A two-dimensional fast Fourier transform (2D-FFT) is applied to out-of-plane velocity data captured experimentally using LDV to go from the time-spatial domain to frequency-wavenumber domain. The result is a 2D array of amplitudes at discrete frequencies and wavenumbers for A0 mode in a given propagation direction along the composite. The peak values of the curve are then used to construct frequency wavenumber and phase velocity dispersion curves, which are also obtained directly using Snell’s law and the incident angle of the excited ultrasonic waves. A high resolution and strong correlation between numerical and experimental results are observed for dispersive curves with Snell’s law method in comparison to 2D-FFT method. Dispersion curves as well as velocity curves for the composite plate along different directions of wave propagation are measured. The visual read-out of the dispersion curves at different propagation directions as well as the phase velocity curves provide profiling and measurements of the composite anisotropy. The results proved a high sensitivity of the air-coupled and laser ultrasound technique in non-contact characterization of Lamb wave dispersion and material anisotropy of composite plates using simple Snell’s law method.

Non-destructive testing of composite plates by holographic vibrometry

Vibration-Based In-Situ Detection and Quantification of Delamination in Composite Plates

Experimental Investigation of Damage Detection in Composite Material Structures Using a Laser Vibrometer and Piezoelectric Actuators

Delamination Detection and Localization in Vibrating Composite Plates and Shells Using the Inverse Finite Element Method

Damage Identification in Various Types of Composite Plates Using Guided Waves Excited by a Piezoelectric Transducer and Measured by a Laser Vibrometer

Delamination Detection in Composite Plates Using Linear and Nonlinear Ultrasonic Guided Waves

Defect Detection and Imaging in Composite Structures Using Magnetostrictive Patch Transducers

Local wavenumber imaging with low-sampled wavefield for delamination characterization in composite plate

Impact damage detection in composite chiral sandwich panels using nonlinear vibro-acoustic modulations

Delamination Detection of Composite Plates Using Piezoceramic Patches and Wavelet Packet Analysis

Guided Ultrasonic Wave Monitoring of Damage in Anisotropic Composites

Monitoring damage in composite plates from crack initiation to macro-crack propagation combining linear and nonlinear ultrasonic techniques

Guided wave resonance identification of interface delamination in bimaterial composites

Damage Detection Of Composite Laminates Based On Vibration Testing

Scattering of guided waves at delaminations in composite plates

Delamination inspection in composite laminates with S0 Lamb wave using flexible macro-fiber composite transducers

Lamb wave dispersion and anisotropy profiling of composite plates via non-contact air-coupled and laser ultrasound

Wave Propagation in Aluminum Honeycomb Plate and Debonding Detection Using Scanning Laser Vibrometer.

Nondestructive Testing of Composite Materials: An In-Depth Study Using Ultrasonic Immersion Inspection

Nondestructive Testing of Thin Composite Structures for Subsurface Defects Detection Using Dynamic Laser Speckles

A new methodology of Non-Destructive Testing in a set of two parallel immersed plates using time reversal process and Leaky Lamb waves