Abstract:Japan started the national project "COURSE 50" for CO 2 reduction in the 2000s. This project aimed to establish novel technologies to reduce CO 2 emissions with partially utilization of hydrogen in blast furnace-based ironmaking by 30% by around 2030 and use it for practical applications by 2050. The idea is that instead of coke, hydrogen is used as the reducing agent, leading to lower fossil fuel consumption in the process. It has been reported that the reduction behavior of hematite, magnetite, calcium ferrite, and slag in the sinter is different, and it is also considerably influenced by the sinter morphology. This study aimed to investigate the reduction behavior of sinters in hydrogen enriched blast furnace with different mineral morphologies in CO—CO 2 —H 2 mixed gas. As an experimental sample, two sinter samples with significantly different hematite and magnetite ratios were prepared to compare their reduction behaviors. The reduction of wustite to iron was carried out at 1000, 900, and 800°C in a CO—CO 2 —H 2 atmosphere for the mineral morphology-controlled sinter, and the following findings were obtained. The reduction rate of smaller amount of FeO led to faster increase of the reduction rate curve at the initial stage of reduction. Macro-observations of reduced samples showed that the reaction proceeded from the outer periphery of the sample toward the inside, and a reaction interface was observed where reduced iron and wustite coexisted. Micro-observations revealed three layers, namely, wustite single phase in the center zone of the sample, iron single phase in the outer periphery zone of the sample, and iron oxide-derived wustite FeO and iron, or calcium ferrite-derived wustite 'FeO' and iron in the reaction interface zone. A two-interface unreacted core model was successfully applied for the kinetic analysis of the reduction reaction, and obtained temperature dependent expressions of the chemical reaction coefficients from each mineral phases.

Nitrogen monoxide reduction by carbon monoxide to combustion control with calcium ferrite redox in iron ore sintering

Effect of Ca-Fe oxides additives on NOx reduction in iron ore sintering

Density Functional Theory Study on the Reduction of NO by CO over Fe3O4 (111) Surface

Influence of Coke Combustion on NOx Emission During Iron Ore Sintering

Modeling NOx Emission of Coke Combustion in Iron Ore Sintering Process and Its Experimental Validation

Catalysis of metal oxide for NOx reduction via retraining with pulverized coal

Catalysis of Metal Oxide for NOx Reduction Via Reburning with Pulverized Coal

Coupling effect of Fe-based catalyst on Nitrogen oxides control in the process of nitrogen reduction and combustion denitration of long flame coal pyrolysis

Catalytic reduction of nitrogen monoxide using iron–nickel oxygen carriers derived from electroplating sludge: Novel method for the collaborative emission decrease of polluting gases

The decomposition of Fe-substituted rhodochrosite during coaling enhanced the transformation of NO before catalyst bed: Effect of instant-calcination

Comparative study of MCe0.75Zr0.25Oy (M = Cu, Mn, Fe) catalysts for selective reduction of NO by CO: Activity and reaction pathways

Insights into the highly activity CuMgFe oxides for the selective catalytic reduction of NO by CO: Structure-activity relationships and K/SO2 poisoning mechanism

Role and Reduction of NOx in the Catalytic Combustion of Soot over Iron–ceria Mixed Oxide Catalyst

Bifunctional Catalyst of CuMn-HZSM-5 for Selective Catalytic Reduction of NO and CO Oxidation under Oxygen Atmosphere

Effect of calcium-based additives on NO release of coals under different combustion modes

Investigation of Fe-Ni Mixed-Oxide Catalysts for the Reduction of NO by CO: Physicochemical Properties and Catalytic Performance

Recent advancements in Fe-based catalysts for the efficient reduction of NOx by CO

Effect of iron minerals during coaling on the transformation of NO in the presence of NH3: Take pyrite as an example

Combustion Characteristics of Different Types of Quasi-Particles in Iron Ore Sintering Process

Promotion effect of Ni doping on the oxygen resistance property of Fe/CeO2 catalyst for CO-SCR reaction: Activity test and mechanism investigation

Effect of FeO concentration in sinter iron ore on reduction behavior in a hydrogen-enriched blast furnace