Time in DNB experimental study on Cr coated zircaloy cladding
Tiago A. Moreira,Keegan D. Murray,Michael E. Conner,Yixing Sung,Jorie Walters,Benjamin R. Maier,Carrie Wood,Kirkland D. Broach,Zeses Karoutas,Mark H. Anderson
DOI: https://doi.org/10.1016/j.applthermaleng.2024.123266
IF: 6.4
2024-05-04
Applied Thermal Engineering
Abstract:Since the Fukushima-Daiichi accident effort has been put in by the nuclear community to develop Accident Tolerant Fuel (ATF) cladding materials to reduce the risk of clad oxidation and, consequently, hydrogen generation and potential major accidents. Among designed materials, the use of a chromium coating on top of zirconium-alloy cladding showed reasonable results in preliminary tests, being a favorable cladding solution for Pressurized Water Reactors. This paper provides highly detailed temperature data obtained during time in departure from nucleate boiling (DNB) experiments under prototypical reactor conditions of temperature, pressure, mass flux, and heat flux profile on a Cr-coated zirconium-alloy cladded heater rod simulating the fuel pin. Data were obtained at mass fluxes from 1300 to 1700 kg/m 2 s, pressure of 16 MPa, and inlet temperature of 333 °C (subcooling degree of 14.4 °C). The change in dry time was obtained by increasing the spike in wall temperature necessary to shut down the power. These tests showed that increasing the spike in temperature to characterize the critical heat flux from 50 °C to 400 °C resulted in variations of the departure from nucleate boiling measured value within the uncertainty range of their measurements, hence, validating the use of a spike of 50 °C, a commonly used value in this kind of study, as an indicator of the critical heat flux. Within the dry region, the temperature was found to increase along the direction of the flow for a very short length, reaching a peak, from which it reduces linearly until the surface reaches a temperature that is no longer able to sustain a dry patch. It was noticed that the dry region can grow against the flow direction due to the cosine profile of the heat flux, and that small dryout events can occur without leading to departure from nucleate boiling, i.e., being fully suppressed. However, two consecutive events may sum up and cause the critical heat flux. Rewet time was found to increase with peak cladding temperature and decrease with mass flux. A maximum peak cladding temperature of 844 °C was found, with the surface remaining dry for approximately 14.1 s. The minimum film boiling temperature was measured during the rewet process, showing absolute values of around 580 °C, and difference between wall and inlet temperatures of about 240 °C. A post-inspection using microscope and X-ray images showed no damage to the cladding and heater structure, differently than what was noticed for the bare zircaloy in a previous study. This indicated that the presence of chromium coated cladding can improve the oxidation resistance of the cladding not only in short critical heat flux transients but also in longer events associated with major accidents, like a Loss of Coolant Accident.
energy & fuels,engineering, mechanical,mechanics,thermodynamics