Abstract:In order to directly observe the conversion between guided-wave modes and leaky-wave modes in a periodic structure, quadrilateral periodic metal diaphragms arranged in two ways on metal surfaces were analyzed. In the first scheme, each unit cell in the periodic structure contains a metal diaphragm, of which the dispersion characteristics of periodic structures were analyzed by the finite element method. The results of the numerical simulation show that by adjusting lattice constants of periodic structures and geometrical parameters of metal diaphragms, the transmission bandwidth of the present 1-D periodic metal diaphragm structures could be limited to X-band, where the transmission characteristics are easy to be measured. In the second scheme, a pair of mirror-symmetric and staggered quadrilateral metal diaphragms is introduced into a unit cell. It can be found in the theoretical calculation that a new dispersion curve, which passes through the light line in a high frequency range, can be exhibited. The propagation constants of dispersion curves become complex numbers and provide highly directional electromagnetic radiation that scans as the frequency changes. After the relative positions of the two metal diaphragms were properly adjusted, the frequency range of the forbidden band gap between two dispersion curves can be minimized, so as to increase the transmission bandwidth of the 1-D periodic metal structures. The experimentally measured results show that the dispersion curves of the two periodic structures were highly consistent with the theoretical results. The narrowing of the band gap could be verified by measuring the $S$ -parameters. The near-field measurement of the periodic metal structures can demonstrate the conversion between the guided-wave modes and the leaky-wave modes, and the far-field measurement can show the frequency dependence of beam elevation. We expect that these artificial material structures could be widely used for designing new microwave and terahertz band devices.

Bandgaps and topological interfaces of metabeams with periodic acoustic black holes

A Direct Near-Field Observation of Conversion Between Waveguide Modes and Leaky Modes in Periodic Metal Structures

Band-Gap Properties of Elastic Metamaterials with Inerter-Based Dynamic Vibration Absorbers

A novel periodic beam with multilayer acoustic black holes for deep sub-wavelength vibration attenuation

A study on vibration localization and energy harvesting of periodic acoustic black hole structure

Wave propagation and vibration attenuation in spiral ABH metamaterial beams

Realization of topological Bragg and locally resonant interface states in one-dimensional metamaterial beam-resonator-foundation system

Actively Controllable Flexural Wave Band Gaps in Beam-Type Acoustic Metamaterials with Shunted Piezoelectric Patches

Wave Dispersion in One-Dimensional Periodic Graded Metacomposites

Enhanced Energy Transfer and Multimodal Vibration Mitigation in an Electromechanical Acoustic Black Hole Beam

Attenuation band splitting in a finite plate strip with two-dimensional acoustic black holes

Theoretical modeling and vibration characteristics analysis of acoustic black hole beam

Beam-type acoustic black holes incorporating the microstructure-dependent nonlocal effect

Tuning Bandgaps in Metastructured Beams: Numerical and Experimental Study

Wave dispersion in a phononic metaplate with Boater-like cells

Investigation on energy harvesting using bandgaps of periodic acoustic black hole structure

Ultra-low frequency broadband gap optimization of 1D periodic structure with dual power-law acoustic black holes

Optimization of novel plate acoustic metamaterials and modulation of the low-frequency bandgap

Low-frequency and broadband vibration absorption of a metamaterial plate with acoustic black hole resonators

Quasi-periodic sonic black hole with low-frequency acoustic and elastic bandgaps

Resonance mode analysis of finite plate strip with acoustic black holes: the gap between bandgap and attenuation band