Abstract:Recently, the study on elastic waves in phononic crystal plates is becoming a research hotspot due to its potential applications, especially in wireless communication, transducer and sensor system [1-10]. The phononic crystal plates commonly consist of two materials with large contrast in elastic properties and densities, arranging in a periodic (or quasiperiodic) array. The absolute band gaps in composite plates can forbid the propagation of all elastic wave modes in all directions. Comparing with the bulk wave and surface acoustic wave devices, phononic crystal plates have better performance in elastic wave propagation since the phase speed of most Lamb wave modes (except for A0 mode) is faster than surface wave mode, and also the wave energy in plates is totally confined between the upper and nether free-stress boundaries regardless of the air damp and self-dissipation, which provides a special potentiality in micro-electronics in wireless communication. The propagation of Lamb waves is much more complicated than bulk wave and surface acoustic wave in terms of the free-stress boundaries which can couple the longitudinal and transversal strain components. The first attempt to describe the propagation of Lamb waves with wavelength comparable with the lattice is due to Auld and co-workers [11-12], who studied 2D composites within the couple-mode approximation. Alippi et al. [13] have presented an experimental study on the stopband phenomenon of lowest-order Lamb waves in piezoelectric periodic composite plates and interpreted their results in terms of a theoretical model, which provides approximate dispersion curves of the lowest Lamb waves in the frequency range below the first thickness mode by assuming no coupling between different Lamb modes. The transmissivity of the finite structure to Lamb wave modes was also calculated by taking into account the effective plate velocities of the two constituent materials [14]. Based on a rigorous theory of elastic wave, Chen et al.[1] have employed plane wave expansion (PWE) method and transient response analysis (TRA) to demonstrate the existence of stop bands for lower-order Lamb wave modes in 1D plate. Gao et al.[8] have developed a virtual plane wave expansion (V-PWE) method to study the substrate effect on the band gaps of lower-order Lamb waves propagating in thin plate with 1D phononic crystal coated on uniform substrate. They also studied the quasiperiodic (Fibonacci system) 1D system and find out the existence of split in phonon band gap [2]. In order to reduce the computational complexity without losing the accuracy, Zhu et al.[9] have promoted an efficient method named harmony response analysis (HRA) and supercell plane wave expansion (SC PWE) to study the behavior of Lamb wave in silicon-based 1D composite plates. Zou et al.[10] have employed V-PWE method to study the band gaps of plate-mode waves in 1D piezoelectric composite plates with substrates.

Wave dispersion in a phononic metaplate with Boater-like cells

Multi-band Design for One-Dimensional Phononic Crystals

Defect Mode-Induced Unidirectional Flexural Wave Transmission Using Prismatic Beams with Concentrated Gradient Masses

Mechanical metastructure with embedded phononic crystal for flexural wave attenuation

Three-dimensional Chiral Meta-Plate Lattice Structures for Broad Band Vibration Suppression and Sound Absorption

Flexural Wave Manipulation in Perforated Metamaterial Plates with Acoustic Black Holes Interconnected by Piezoelectric Studs

Mathematical Modelling of Phononic Nanoplate and Its Size-Dependent Dispersion and Topological Properties

Wave propagation in elastic metamaterial beams and plates with interconnected resonators

Acoustic Waves In Phononic Crystal Plates

Bandgaps and topological interfaces of metabeams with periodic acoustic black holes

Wave Dispersion in One-Dimensional Periodic Graded Metacomposites

Design of Low-Frequency 1D Phononic Crystals Harnessing Compression–twist Coupling Effect with Large Deflection Angle

Mode Hybridization at Subwavelength Scale in Acoustic Metamaterials

Sub-Bragg Phenomena in Multilayered Vibroacoustic Phononic Metamaterials

Band Structures of Phononic-Crystal Plates in the Form of A Sandwich-Layered Structure

Actively Controllable Flexural Wave Band Gaps in Beam-Type Acoustic Metamaterials with Shunted Piezoelectric Patches

Elastic wave attenuation in a metaplate with periodic hollow shapes for vibration suppression

Phononic Thin Plates with Embedded Acoustic Black Holes

Data-driven design and optimization of ultra-tunable acoustic metamaterials

Multi bandgaps design of sandwich metamaterial plate with embedded membrane-type resonators

Optimization of novel plate acoustic metamaterials and modulation of the low-frequency bandgap