Abstract:Plastic package are widely applied in the field of consumer electronics and other microelectronic packaging because of its advantages including small size, light weight, low cost and outstanding mechanical properties. Due to significant differences of properties among components within the package, especially the coefficient of thermal expansion (CTE) mismatch, extensive internal stresses and strain exist during switching on and off operation of the components. This paper proposed a novel PCB substrate with cavity or inner compliant layer beneath the SMT component package to reduce the stress and strain of corner solder joints in order to enhance the package reliability. Finite element method was applied to analyze the thermomechanical performance of solder balls. Cavity area and thickness are optimized to achieve the minimum strain or stress of solder balls. Material choice filled in the cavity as inner compliant layer is also analyzed by adjust the key material properties. Simulated switching on and off operation process was conducted to analyze the thermomechanical performance of solder ball joints reflowed on the optimized PCB structure. By comparison with the simulation results between the new substrate and traditional substrate, the performance of the new substrate is proved to be excellent. Compared with the traditional substrate, when the component was attached on the optimized PCB board, the viscoplastic stain of corner solder joints could be reduced from 0.0108 to 0.0064 while the deformation of PCB board remained almost unchanged, thus the reliability of solder improved a lot.

Cause analysis on the unqualified pull-out force between the bushing and PCB pad in DC-DC converters for new energy vehicles

Cause analysis on abnormal failure of copper-substrate pin fin heat sink for new energy vehicle

Reliability Analysis of Power Components in Restructured DC/DC Converters

Failure analysis on the premature delamination in the power module of the inverter for new energy vehicles

Failure analysis on the pin fin heat sink for the power module of new energy vehicles

The Two-Phase Flow Simulation and Experimental Research on the Formation of Solder Voids in Power Module

Review of High Power DC/DC Soft-Switching Converters in Electrical Vehicles Application

Research on PCB layout optimization of vehicle controller based on electrothermal hybrid simulation

Electro-thermal comprehensive analysis method for defective bushings in HVDC converter transformer valve-side under multiple-frequency voltage and current harmonics

Analyses and Design of a High Power Bidirectional 48V-12V DCDC Converter System for Electric Vehicle Application.

Research on Factors Influencing the Board Level Product Quality

Reliability Sensibility Analysis of the PCB Assembly concerning Warpage during the Reflow Soldering Process

Multiphysics Analysis Of The Busbar In Mmc Submodule Under Dc Pole-To-Pole Fault

Failure Analysis of BGA Solder Joint in PCB for Novel Mobile Phones

Failure Analysis on Electrolytic Ni/Au Surface Finish of Pcb Used for Wire Bonding and Soldering

Investigation on electromigration failure behavior of SAC305/SnPb micro-hybrid solder joints for package-on-package techniques: Experiment and simulation

A Method for Separation of Power Semiconductor Packaging-Related Wear-Out Mechanisms Under Converter Operation

Quad Flat No-Lead Package With Different Thermal Profiles And Solder Pad Finishing For Void Minimization

Cause Analysis on the Abnormal Failure of SiC Power Modules During the HV-H3TRB Tests

Analysis of Discharge Caused by Soldering Defect in Wire-Bonding Power Module

Optimization of PCB Board to Improve Thermomechanical Reliability of Lead-Free Solder Ball Joint