Abstract:In the planar flow casting process of amorphous strips, the flow behavior of molten metal and the inclusion content in the crucible are crucial to the morphology and magnetic properties of the material. This study conducts a comparative analysis of the effects of non-immersed and immersed funnels, as well as various funnel structures, on the fluid flow and inclusion removal efficiency in the crucible by integrating numerical and physical models. The findings reveal that for the same pouring flow rate, the diameter of the liquid column in non-immersed pouring conditions is smaller than that of the funnel outlet, leading to a faster injection flow velocity. As a result, the melt in the crucible is subjected to severe impacts, accompanied by an increased possibility of slag entrapment. Conversely, immersed pouring substantially reduces the velocity of the molten metal at the funnel outlet, thereby extending the residence time in the crucible and diminishing the volume of the dead zone. Additionally, the molten metal backflows due to the negative pressure formed in the inner chamber of the funnel. The design of a trumpet-shaped funnel increases the effective volume while reducing the height of the backflow fluid, consequently reducing the velocity of the molten metal at the funnel outlet and prolonging the residence time. Compared to the conventional pouring process with the non-immersed funnel, the outlet velocity is reduced from 1.1 m/s to 0.12 m/s by adopting the immersed funnel with an inverted trapezoidal trumpet structure. This reduction results in a stable flow state, a 9.69% reduction in the dead zone volume fraction, and a 22.96% increase in average inclusion removal efficiency. These improvements demonstrate that a crucible funnel with a well-designed structure and the implementation of an immersion process can significantly improve the metallurgical effects in the planar flow casting process.

Research on the Advantages of Vortex Smelting Reduction of High-Iron Red Mud (Bauxite Residue)

Experimental Research on Vortex Melting Reduction of High-Iron Red Mud (Bauxite Residue)

Investigation of the smelting reduction mechanism and of iron extraction from high-iron red mud

Suppression effect of a steady magnetic field on molten pool during laser remelting

Numerical Investigation About the Effect of Axial Static Magnetic Field on Improvement of Metal Pool Profile During Electroslag Remelting Process

Experiments on effect of red mud-based slag on distribution of sulfur in liquid iron

Numerical Simulation of Multiphase Flow in Ironmaking Process for Oxygen-Rich Side-Blown Bath Smelting Furnace

An efficient and clean utilization technique for red mud based on fluidized bed carbon monoxide reduction

Optimizing Design of Vortex Suppression Utilizing Static Electromagnetic Field during Steel Teeming from Ladle

Factors Affecting the Mixing Characteristics of Molten Steel in the RH Refining Process

Study on Magnetization Roasting Kinetics of High-Iron and Low-Silicon Red Mud

Reductive roasting of red mud with carbon and sulfuric acid dissolution of iron and aluminum: Transformation phases and leaching characteristics

Effect of bottom stirring on bath mixing and transfer behavior during scrap melting in BOF steelmaking: A review

A novel approach for the resource utilization of zinc-bearing dust and sludge via the blast furnace main trough

Numerical Simulation of Bottom-Blowing Stirring in Different Smelting Stages of Electric Arc Furnace Steelmaking

Modeling Assessment of Recovering Iron from Red Mud by Direct Reduction: Magnetic Separation Based on Response Surface Methodology

Effect of Pouring Techniques and Funnel Structures on Crucible Metallurgy: Physical and Numerical Simulations

Iron Recovery from Bauxite Tailings Red Mud by Thermal Reduction with Blast Furnace Sludge

Carbothermal reduction of red mud for iron extraction and sodium removal

Numerical simulation of flow characteristics of side-bottom combined blowing in iron bath reactor

Iron Extraction from Red Mud using Roasting with Sodium Salt