Abstract:As we know, 3DPC is printed layer by layer compared with mold-casting conventional concrete. Pore structure and layer-to-layer interface are two main aspects of the internal structure for 3DPC, which decide 3DPC's mechanical performance. The layer-to-layer interface caused by printing is specific to 3DPC. The emphasis of this study lies in the layer-to-layer interfaces of 3DPC. The first aim of this study is to quantify the characteristics of the layer-to-layer interface and therefore characterize different aspects of the interfaces. The second aim of this study is to explore how the internal structure of printed concrete influences the mechanical performance of 3DPC. This research set out to design a series of experimental comparisons between 3DPC and casted concrete with the same compositions. Mechanical tests, i.e., compressive stress, ultrasonic Pulse Velocity test, flexural tension, and tension splitting, as well as the Ultrasonic Pulse Velocity test, were performed to check the mechanical performance of 3DPC. Contrary to what has often been expected, the mechanical test results showed the printed concrete has a quality not worse than casted concrete with the same recipe. Meanwhile, the X-ray computed tomography (X-CT) is used to characterize the internal structure, pore shapes, and interfaces of 3DPC. First, the investigation revealed that the lower total porosity and fewer big voids could be the fundamental causes meaning 3DPC has a better mechanical performance than casted concrete. Second, the statistics based on aspect ratio show that the distribution curves follow similar trends, regardless of the printed or casted concrete. Third, this study quantified the depth of the different interfaces for 3DPC. The results suggest that the porosity in an interface varies in a range. The author's pioneer work has contributed to our present understanding of the interfaces of 3DPC.

Effects of Nozzle Details on Print Quality and Hardened Properties of Underwater 3D Printed Concrete

Investigation of the Internal Structure of Hardened 3D-Printed Concrete by X-CT Scanning and Its Influence on the Mechanical Performance.

Comparison of Properties of 3D-Printed Mortar in Air vs. Underwater

Nozzle criteria for enhancing extrudability, buildability and interlayer bonding in 3D printing concrete

Extrusion nozzle design and print parameter selections for 3D concrete printing

Influential factors on mechanical properties and microscopic characteristics of underwater 3D printing concrete

Development of a 3D Printer for Concrete Structures: Laboratory Testing of Cementitious Materials

Three-Dimensional Printable Concrete by an Ultra-Thin Nozzle and Fully Sealed Extrusion

The effects of nozzle diameter and length on the resulting strand properties for shotcrete 3D printing

3D Printed Concrete: Fresh and Hardened Properties

Shotcrete 3D Printing ‐ Interaction of nozzle geometry, homogeneity and hardened concrete properties

Influence of print speed and nozzle diameter on the fiber alignment in 3D printed ultra-high-performance concrete

Development of novel concave and convex trowels for higher interlayer strength of 3D printed cement paste

Prototype Nozzle for Three-Layer 3D Concrete Printing

Effect of Nanostructured Silica Additives on the Extrusion-Based 3D Concrete Printing Application

Numerical Simulation of 3D Concrete Printing Derived from Printer Head and Printing Process

Hardened properties of 3D printed concrete: The influence of process parameters on interlayer adhesion

Influence of pore defects on the hardened properties of 3D printed concrete with coarse aggregate

3D Concrete Printing: A Systematic Review of Rheology, Mix Designs, Mechanical, Microstructural, and Durability Characteristics

Effects of Extrusion Parameters on Properties of 3d Printing Concrete with Coarse Aggregates

Strength and Proportioning Design of 3D Printed Concrete (3DPC) Based on Aggregate Gradation Optimization