Abstract:One low density polyethylene (LDPE) resin with high-speed extrusion coating property is fractionated through solvent gradient fractionation (SGF) technique using 1,2,4-trimethylbenzene (TMB) and ethyl cellosolve (ECS) as good/poor solvent pair at 115 °C. The pristine sample and its fractions are characterized by high-temperature gel permeation chromatography (HT-GPC) coupled with triple detectors (refractive index RI, light scattering LS, viscometer VIS), 13C–nuclear magnetic resonance spectroscopy (13C–NMR), differential scanning calorimetry (DSC) and successive self-nucleation/annealing (SSA) thermal fractionation. By adjusting the ratio of good/poor solvent, the obtained fractions show their molecular weight from 1.58 × 103 g/mol to 4.76 × 105 g/mol. It is found that the fractions with high molecular weight (fractions 10–13) occupy about 55.85% in resin. Particularly, the molecular weight distribution (MWD) of most fractions is in the range of 1.1–1.2. Each fraction contains more short chain branch (SCB) and less long chain branch (LCB) simultaneously. With increasing the molecular weight, the branching content shows no regular change. The lowest SCB and total branch content regions correspond to molecular weight 1.97 × 104 to 4.10 × 104 g/mol. The melting and crystallization temperatures of fractions firstly increase and then decrease with the molecular weight. The crystallinity decreases gradually from 51.7% to 31.1%. In the SSA thermal fractionation, each fraction shows a broad range of endotherm with multiple melting peaks in DSC curve corresponding to the different methylene sequence length (MSL) (Ln and Lw). The longest Ln (Lw) region occurs in the molecular weight of 8.95 × 103 to 3.14 × 104 g/mol. The relationship between chain microstructure and properties is also discussed.Graphical AbstractOne coating LDPE resin is effectively fractionated by solvent gradient fractionation using TMB/ECS as good/poor solvent pair according to molecular weight. The component with high molecular weight is more than that with low molecular weight. Higher molecular weight and LCB improve the melt strength synergetically, and suitable component with low molecular weight provides better flowability.

Enhanced characterization of the chemical structure of high-density polyethylene by size exclusion/thermal fractionation on poly(styrene-co-divinylbenzene) columns

Characterization of Low-Density Polyethylene in Dibutoxymethane by High-Temperature Gel Permeation Chromatography with Triple Detection

Preparation of High Density Polyethylene/polyethylene- Block -Poly(ethylene Glycol) Copolymer Blend Porous Membranes Via Thermally Induced Phase Separation Process and Their Properties

Study of Polyethylene Solution Fractionation and Resulting Fractional Crystallization Behavior

Study on Solution Fractionation and Crystallization of HDPE

A Study of the Degradation of Polyethylene by High‐temperature Dynamic Light‐scattering

Characterization of Intramolecular Composition Heterogeneity of Metallocene-Based and Conventional Ethylene-Butene Copolymers Using Tref/Dsc

Application of Temperature Rising Elution Fractionation in Polyolefins

Calibration curve establishment and fractionation temperature selection of polyethylene for preparative temperature rising elution fractionation

Microstructure characterization of one high-speed extrusion coating polyethylene resin fractionated by solvent gradient fractionation

Probing Liquid‐Liquid Phase Separation of a Polyethylene Blend with Thermal Analysis

High temperature‐size exclusion chromatography with triple detection to assess the molecular architecture of low‐density polyethylene: Insight into branching and processability correlations

Characterisation of Formulated High-Density Poly(ethylene) by Magic Angle Spinning Nuclear Magnetic Resonance

Separation of short-chain branched polyolefins by high-temperature gradient adsorption liquid chromatography

Characterization of Broad Molecular Weight Distribution Polyethylene with Multi-Detection Gel Permeation Chromatography

Temperature rising elution fractionation of polypropylene produced by heterogeneous Ziegler-Natta catalysts

Liquid–liquid Phase Separation in a Polyethylene Blend Monitored by Crystallization Kinetics and Crystal-Decorated Phase Morphologies

Modeling of the Molecular Weight Distribution and Short Chain Branching Distribution of Linear Low-Density Polyethylene from a Pilot Scale Gas Phase Polymerization Process

Improved Thermal Fractionation Technique for Chain Structure Analysis of Ethylene/α-Olefin Copolymers

Study on molecular chain heterogeneity of linear low-density polyethylene by cross-fractionation of temperature rising elution fractionation and successive self-nucleation/annealing thermal fractionation

Short Chain Branches Distribution Characterization of Ethylene/1‐Hexene Copolymers by Using TREF + 13C‐NMR and TREF + SC Methods