Abstract:Aero-engine nacelles have to fulfill design requirements at both cruise and off-design conditions. Under engine windmilling conditions the ingested streamtube massflow is relatively low. A key off-design condition is take-off, which, in conjunction with an engine windmilling scenario, results in the stagnation point of the ingested streamtube being located significantly inside the intake. The combination of high angle of attack and low engine massflow rates leads to a strong flow acceleration and subsequent diffusion of the boundary layer on the upper quadrants of the external nacelle cowl, which can terminate with subsonic separation from the leading-edge. Under this condition, Reynolds number effects can play a dominant role on the separation onset and characteristics and 3D-annular wind tunnel tests cannot always achieve Reynolds' number equivalent to full scale. A novel quasi-2D rig configuration representative of the aerodynamics of a full-size aero-engine nacelle under windmilling end of runway conditions examined in detail the characteristics of the boundary layer on the external cowl of a nacelle prior to diffusion-induced separation. Separation of the boundary layer was independently promoted through changes to represent different engine massflow rates and freestream Mach number on the rig to determine the limits of steady Reynolds Averaged Navier Stokes (RANS) methods to discern the onset of boundary layer separation. For the conditions and geometry investigated, the combined experimental and computational results showed that there was laminar to turbulent transition of the boundary layer ahead of the subsonic diffusion. The work showed that steady RANS can predict the onset of boundary layer separation with an uncertainty of approximately 10% on notional engine massflow rate and 0.05 on freestream Mach number relative to a nominal operating freestream Mach number of 0.25. This provides guidance for the industrial design and optimization of future windmilling-tolerant nacelles for large ultra-high bypass ratio turbofan engines.

Numerical study of the separation of a turbulent boundary in rocket engine nozzles with an optimized supersonic part

Numerical simulation research of high altitude reverse jet flow for stage separation of missile

Numerical Study of Heat Flux Reduction Mechanism of the Counterflowing Jet in Rarefied Flows

NUMERICAL INVESTIGATION OF SUPERSONIC FLOW SEPARATION IN THRUST-OPTIMIZED CONTOUR ROCKET NOZZLE

Design and Optimization of Three-Dimensional Supersonic Asymmetric Truncated Nozzle

Numerical Study on the Influence of Separation Time Sequence on the Initial Thermal Separation

Computational modeling of heat transfer and flow separation in supersonic cooled nozzles: Parametric study

Numerical investigation of vented plume into a supersonic flow in the early stage of rocket hot separation

Numerical Investigation of Separated Plug Nozzle Flow

Shock Wave and Aeroelastic Coupling in Overexpanded Nozzle

STUDY ON NUMERICAL SIMULATIONS OF A PLUG NOZZLE FOR ROCKET ENGINE

Numerical and experimental investigations of diffusion-induced boundary layer separation on aero-engine nacelles

Numerical Study on Turbulent Convective Heat Transfer with n-heptane Under Supercritical Pressures

Study on Separation Characteristics of Nozzles with Large Expansion Ratio of Solid Rocket Motors

Numerical Simulation Coupling on Fluid Flow and Heat Transfer in Nozzle and Equipment Cabin of Solid Rocket Motor during Operation Process

Numerical Study of Supersonic Film Cooling in Diverging Section of Nuclear Rocket Laval Nozzle

Numerical Modeling of Turbulent Heat Transfer of a Nanofluid at Supercritical Pressure

Numerical investigation of surface roughness effects on non-equilibrium flow in expansion section of rocket nozzle

Trihybrid nanofluid flow through nozzle of a rocket engine: Numerical solution and irreversibility analysis

Based on Fluent Numerical Calculation of Refractive Index on Rocket Engine Nozzle Plume

Modeling and Analysis of Fluid-Solid Coupling Heat Transfer and Fluid Flow in Transonic Nozzle