Abstract:Aero-engine nacelles have to fulfill design requirements at both cruise and off-design conditions. Under engine windmilling conditions the ingested streamtube massflow is relatively low. A key off-design condition is take-off, which, in conjunction with an engine windmilling scenario, results in the stagnation point of the ingested streamtube being located significantly inside the intake. The combination of high angle of attack and low engine massflow rates leads to a strong flow acceleration and subsequent diffusion of the boundary layer on the upper quadrants of the external nacelle cowl, which can terminate with subsonic separation from the leading-edge. Under this condition, Reynolds number effects can play a dominant role on the separation onset and characteristics and 3D-annular wind tunnel tests cannot always achieve Reynolds' number equivalent to full scale. A novel quasi-2D rig configuration representative of the aerodynamics of a full-size aero-engine nacelle under windmilling end of runway conditions examined in detail the characteristics of the boundary layer on the external cowl of a nacelle prior to diffusion-induced separation. Separation of the boundary layer was independently promoted through changes to represent different engine massflow rates and freestream Mach number on the rig to determine the limits of steady Reynolds Averaged Navier Stokes (RANS) methods to discern the onset of boundary layer separation. For the conditions and geometry investigated, the combined experimental and computational results showed that there was laminar to turbulent transition of the boundary layer ahead of the subsonic diffusion. The work showed that steady RANS can predict the onset of boundary layer separation with an uncertainty of approximately 10% on notional engine massflow rate and 0.05 on freestream Mach number relative to a nominal operating freestream Mach number of 0.25. This provides guidance for the industrial design and optimization of future windmilling-tolerant nacelles for large ultra-high bypass ratio turbofan engines.

Numerical Study on the Influence of Separation Time Sequence on the Initial Thermal Separation

Numerical simulation research of high altitude reverse jet flow for stage separation of missile

Numerical investigation of vented plume into a supersonic flow in the early stage of rocket hot separation

Experimental Study and Numerical Simulation of the Characteristics of a Percussive Gas–solid Separator

Numerical study of the separation of a turbulent boundary in rocket engine nozzles with an optimized supersonic part

Experimental and numerical investigation on the unsteady interaction in longitudinal stage separation for parallel-staged two-body configuration

Study on Separation Characteristics of Nozzles with Large Expansion Ratio of Solid Rocket Motors

Shock Wave and Aeroelastic Coupling in Overexpanded Nozzle

Unsteady interaction and dynamic stability analysis of a two-stage-to-orbit vehicle during transverse stage separation

The thermal condition analysis of stage separation for a multistage solid rocket before the nozzle exit cone extend

Computational modeling of heat transfer and flow separation in supersonic cooled nozzles: Parametric study

Numerical simulation of flow field and thermal analysis for stage separation of multistage missile

Intermittent Gas Resonance in Stage Separation Flow Field of Multistage Rocket

NUMERICAL INVESTIGATION OF SUPERSONIC FLOW SEPARATION IN THRUST-OPTIMIZED CONTOUR ROCKET NOZZLE

Coupled Numerical Simulation of the Multi-Stage Rocket Stage Separation

Numerical Simulation Study of Energy Separation in Jet Shear Layer

Numerical Study on Separation Flows of a Compressor Transition Duct

Numerical Simulation Coupling on Fluid Flow and Heat Transfer in Nozzle and Equipment Cabin of Solid Rocket Motor during Operation Process

Numerical simulation of the effects of turbulence intensity and boundary layer on separation efficiency in a cyclone separator

Experimental research and numerical analysis for effect of drainage structure on separation performance and the "blockage" of fluid in nozzle

Numerical and experimental investigations of diffusion-induced boundary layer separation on aero-engine nacelles