Abstract:A very important parameter for the electrocatalytic performance of a material is its potential of zero free charge (pzfc). For Cu(111) at pH 13 it was identified at −0.73 V SHE in the apparent double layer region. It shifts by (88±4) mV to more positive potentials per decreasing pH unit. 1 At the pzfc, Cu(111) starts to restructure. At higher potentials, full reconstruction and electric field dependent OH adsorption occur, causing a remarkable decrease in the atomic density of the first Cu layer. 1 It is this restructuring that enables Cu(111) to efficiently oxidize CO and to reduce water. Therefore, knowledge of the surface structure and the position of the pzfc is of paramount importance for the understanding of copper's catalytic properties and for the rational design of electrocatalysts. CO is a key intermediate in the electro-oxidation of energy carrying fuels and known to act as a catalyst poison. Single-crystal Cu(111) model catalysts can efficiently electro-oxidize CO in alkaline media, 2 where strong surface structural changes are observed under reaction conditions with electrochemical scanning tunneling microscopy (EC-STM). Supported by first-principles microkinetic modelling, we have shown that the concomitant presence of high-energy undercoordinated Cu structures at the surface is a prerequisite for the high activity. In water electrolyzers, it is possible to produce H 2 in the course of the hydrogen evolution reaction (HER), which was studied with Ni(OH) 2 and Co(OH) 2 modified Cu(111) electrodes in alkaline media. 3 Strong morphological changes upon adatom modification lead to a significant HER rate enhancement. Intriguingly, this is induced through a decrease of the electric field strength negative of the pzfc. This implies an easier reorganization of the interfacial water molecules facilitating charge transfer through the double layer, and thus enhancing the efficiency of electrocatalytic reactions. The tendency of Cu(111) to restructure is found to dominate its electrochemical properties. The structural changes of the electrode surface are intimately related to the electric field at the solid/liquid interface and to its electrocatalytic activity, in general. References: [1] A. Auer, X. Ding, A. S. Bandarenka, J. Kunze-Liebhäuser, J. Phys. Chem. C 125 (2021) 5020. [2] A. Auer, M. Andersen, E.M. Wernig, N.G. Hörmann, N. Buller, K. Reuter, J. Kunze-Liebhäuser, Nature Catal. 3 (2020) 797. [3] A. Auer, F.J. Sarabia, D. Winkler, C. Griesser, V. Climent, J.M. Feliu, J. Kunze-Liebhäuser, ACS Catal. 11 (2021) 10324. Figure 1

Anion Influenced Hydride Formation on Cu(111) during Electrocatalysis

Reaction-induced Iodine Adsorption on Cu Surfaces Facilitates Electrocatalytic CO2 Reduction.

Competition between Initial CO2 Electroreduction and Hydrogen Evolution Reaction on Cu Catalysts in Acidic Media: Role of Specifically Adsorbed Halide Anions

Theoretical Understanding on the Effect of Specifically Adsorbed Halide Anions on Cu-Catalyzed CO2 Electroreduction Activity and Product Selectivity

H-Induced Restructuring on Cu(111) Triggers CO Electroreduction in an Acidic Electrolyte

Thermodynamic and Kinetic Competition between C–H and O–H Bond Formation Pathways during Electrochemical Reduction of CO on Copper Electrodes

Surface Water As an Initial Proton Source for the Electrochemical CO Reduction Reaction on Copper Surfaces

Direct Observation on Reaction Intermediates and the Role of Bicarbonate Anions in CO2 Electrochemical Reduction Reaction on Cu Surfaces.

(Invited) Bare and Modified Cu(111) Electrocatalysts: Interfacial Structure and Reactivity

H and CO Co-induced Adatom Formation on Cu in CO2 Electroreduction Conditions

Hydroxyl radicals dominate reoxidation of oxide-derived Cu in electrochemical CO2 reduction

A Computational Perspective on Carbon-Carbon Bond Formation by Single Cu Atom on Pd(111) Surface for CO Electrochemical Reduction

Corrosion and Enhanced Hydrogen Evolution in Electrochemical Reduction of Ammonium Carbamate on Transition Metal Surfaces

Preanodized Cu Surface for Selective CO2 Electroreduction to C1 or C2+ Products

Surface Adsorbed Hydroxyl: A Double-Edged Sword in Electrochemical CO<sub>2</sub> Reduction over Oxide-Derived Copper

Co2 Reduction On Cu At Low Overpotentials With Surface Enhanced In Situ Spectroscopy

Unveiling Ionized Interfacial Water-Induced Localized H* Enrichment for Electrocatalytic Nitrate Reduction

Unveiling the effect of chloride on the surface modification of Cu(111)

Iodide-mediated Cu Catalyst Restructuring during CO2 Electroreduction

Molecular-Scale Insights into Electrochemical Reduction of CO 2 on Hydrophobically Modified Cu Surfaces