Abstract:Cu surfaces are known for their ability to electrochemically convert CO2 and CO into multicarbon (C2+) products. Although the impact of the electrolyte alkalinity on the electrochemical CO2 and CO reduction reactions (CO2RR and CORR, respectively) has been extensively investigated on Cu surfaces, systematic investigation of the pH dependence of the surface Cu speciation has been lacking. Herein, we demonstrate for the first time the pH dependence of Cu surface speciation and CO adsorption configuration in weakly to strongly alkaline electrolytes using in situ surface enhanced Raman spectroscopy. Oxygen-containing species, e.g., CuOx/(OH)(y), are absent in near-neutral electrolyte of KHCO3 (pH = 8.9), and their onset potential becomes more positive with increasing the alkalinity of electrolytes. Concurrently, adsorbed CO transitions from atop-bonded (COatop) to bridge-bonded configuration (CObridge) as the pH of the electrolyte increases. CO is proposed to adsorb in the atop configuration only on Cu sites without neighboring oxygen-containing species, while the appearance of the CObridge band correlates with the presence of the oxygen-containing species. Surface speciation on Cu microparticles (Cu MPs) and oxide-derived Cu (OD-Cu) are similar in all the electrolytes investigated, while the CO adsorption bands show subtle differences on these two surfaces, reflecting variations in the microenvironment of CO adsorbed in the same configuration. Selectivity for C2+ products in the CORR on Cu MPs increases with the electrolyte alkalinity at -0.4 V-RHE, which correlates with the presence of the oxygen-containing Cu species. However, the presence of the oxygen-containing Cu species alone is shown to be an unreliable predictor of the CORR performance on Cu MPs and OD-Cu, which could be attributed to the difference in the microenvironment of the surface Cu sites. Results reported in this work highlight that the assumption that the surface Cu speciation under reducing potentials is independent of the electrolyte pH must be treated with caution.

Hydroxyl radicals dominate reoxidation of oxide-derived Cu in electrochemical CO2 reduction

Understanding Oxidation State of Cu-based Catalysts for Electrocatalytic CO2 Reduction

Role of Subsurface Oxygen on Cu Surfaces for CO2 Electrochemical Reduction

Surface Adsorbed Hydroxyl: A Double-Edged Sword in Electrochemical CO<sub>2</sub> Reduction over Oxide-Derived Copper

Dynamics of bulk and surface oxide evolution in copper foams for electrochemical CO2 reduction

Surface Water As an Initial Proton Source for the Electrochemical CO Reduction Reaction on Copper Surfaces

Understanding the restructuring and degradation of oxide-derived copper during electrochemical CO 2 reduction

Understanding the Restructuring and Degradation of Oxide-Derived Copper During Electrochemical CO2 Reduction

In Situ Infrared Spectroscopic Evidence of Enhanced Electrochemical CO2 Reduction and C-C Coupling on Oxide-Derived Copper

Direct Observation on Reaction Intermediates and the Role of Bicarbonate Anions in CO2 Electrochemical Reduction Reaction on Cu Surfaces.

Ph Dependence Of Cu Surface Speciation In The Electrochemical Co Reduction Reaction

Role of Oxide-Derived Cu on the Initial Elementary Reaction Intermediate During Catalytic CO 2 Reduction

Crucial Effect of Surface Oxygen Species on CO2 Electroreduction Performance in Ti@Cu Single Atom Alloys

Speciation of Cu Surfaces During the Electrochemical CO Reduction Reaction.

Hydroxide is Not a Promoter of C2+ Product Formation in the Electrochemical Reduction of CO on Copper

Molecular Understanding of the Critical Role of Alkali Metal Cations in Initiating CO2 Electroreduction on Cu(100) Surface

New Insights into Influences of Initial Oxidization States on Dynamic Reconstruction of Cu Catalysts and C−C Coupling in CO2 Reduction

Anion Influenced Hydride Formation on Cu(111) during Electrocatalysis

Alkali cation-induced cathodic corrosion in Cu electrocatalysts

Redox-Mediated Reconstruction of Copper during Carbon Monoxide Oxidation