Abstract:Cu surfaces are known for their ability to electrochemically convert CO2 and CO into multicarbon (C2+) products. Although the impact of the electrolyte alkalinity on the electrochemical CO2 and CO reduction reactions (CO2RR and CORR, respectively) has been extensively investigated on Cu surfaces, systematic investigation of the pH dependence of the surface Cu speciation has been lacking. Herein, we demonstrate for the first time the pH dependence of Cu surface speciation and CO adsorption configuration in weakly to strongly alkaline electrolytes using in situ surface enhanced Raman spectroscopy. Oxygen-containing species, e.g., CuOx/(OH)(y), are absent in near-neutral electrolyte of KHCO3 (pH = 8.9), and their onset potential becomes more positive with increasing the alkalinity of electrolytes. Concurrently, adsorbed CO transitions from atop-bonded (COatop) to bridge-bonded configuration (CObridge) as the pH of the electrolyte increases. CO is proposed to adsorb in the atop configuration only on Cu sites without neighboring oxygen-containing species, while the appearance of the CObridge band correlates with the presence of the oxygen-containing species. Surface speciation on Cu microparticles (Cu MPs) and oxide-derived Cu (OD-Cu) are similar in all the electrolytes investigated, while the CO adsorption bands show subtle differences on these two surfaces, reflecting variations in the microenvironment of CO adsorbed in the same configuration. Selectivity for C2+ products in the CORR on Cu MPs increases with the electrolyte alkalinity at -0.4 V-RHE, which correlates with the presence of the oxygen-containing Cu species. However, the presence of the oxygen-containing Cu species alone is shown to be an unreliable predictor of the CORR performance on Cu MPs and OD-Cu, which could be attributed to the difference in the microenvironment of the surface Cu sites. Results reported in this work highlight that the assumption that the surface Cu speciation under reducing potentials is independent of the electrolyte pH must be treated with caution.

Ph Dependence Of Cu Surface Speciation In The Electrochemical Co Reduction Reaction

Surface Water As an Initial Proton Source for the Electrochemical CO Reduction Reaction on Copper Surfaces

Reaction-induced Iodine Adsorption on Cu Surfaces Facilitates Electrocatalytic CO2 Reduction.

Role of Subsurface Oxygen on Cu Surfaces for CO2 Electrochemical Reduction

Speciation of Cu Surfaces During the Electrochemical CO Reduction Reaction.

Electrokinetic and in Situ Spectroscopic Investigations of CO Electrochemical Reduction on Copper.

Cation effect on the elementary steps of the electrochemical CO reduction reaction on Cu

Cation-Dependent Impact of CO2 on Cu-Catalyzed Electrochemical CO Reduction Reaction

Surface Adsorbed Hydroxyl: A Double-Edged Sword in Electrochemical CO<sub>2</sub> Reduction over Oxide-Derived Copper

Hydroxyl radicals dominate reoxidation of oxide-derived Cu in electrochemical CO2 reduction

Using pH dependence for understanding mechanisms in electrochemical CO reduction

Co2 Reduction On Cu At Low Overpotentials With Surface Enhanced In Situ Spectroscopy

Mechanistic Implications of Low CO Coverage on Cu in the Electrochemical CO and CO2 Reduction Reactions

Direct Observation on Reaction Intermediates and the Role of Bicarbonate Anions in CO2 Electrochemical Reduction Reaction on Cu Surfaces.

In Situ Infrared Spectroscopic Evidence of Enhanced Electrochemical CO2 Reduction and C-C Coupling on Oxide-Derived Copper

Reaction Mechanisms for the Electrochemical Reduction of CO2 to CO and Formate on the Cu(100) Surface at 298 K from Quantum Mechanics Free Energy Calculations with Explicit Water

Correlating the Experimentally Determined CO Adsorption Enthalpy with the Electrochemical CO Reduction Performance on Cu Surfaces

Molecular Understanding of the Critical Role of Alkali Metal Cations in Initiating CO2 Electroreduction on Cu(100) Surface

H and CO Co-induced Adatom Formation on Cu in CO2 Electroreduction Conditions

Electrolyte effect for carbon dioxide reduction reaction on copper electrode interface: A DFT prediction

Selectivity of Electrochemical CO 2 Reduction on Metal Electrodes: The Role of the Surface Oxidized Layer