Abstract:The electrochemical CO 2 reduction reaction (CO 2 RR) into value-added multi-carbon products (C 2+ ), using renewable electricity is an attractive strategy for closing the carbon cycle. Electrolysis of gaseous CO 2 using a gas diffusion electrodes (GDEs) enables electrolysis at high current density 1 , and various studies are being conducted for its practical application 2 . Multi-carbon compounds (ethylene, ethanol, acetic acid and n-propanol) can be obtained electrochemically from CO 2 using only Cu-based electrocatalysts. CO 2 RR measurements using Cu-based catalysts have generally been performed in neutral-alkaline electrolytes because the competing H 2 evolution reaction (HER) can be suppressed. However, CO 2 is easily converted to inert (bi)carbonate, which migrates to an anode compartment or is discharged at the outlet of a cathode compartment, and thus, there is a drawback in neutral and alkaline electrolytes from the point of view of substrate utilization efficiency 3 . Therefore, efficient CO 2 RR using acidic solutions has been required. In recent years, although several studies on CO 2 reduction under acidic conditions have been reported 4 , the requirements for C 2+ formation in acidic electrolytes are still uncovered. Direct CO electrolysis is more desirable than CO 2 electrolysis for studying CO dimerization to C 2+ in acidic electrolytes because a constant amount of CO can be supplied to the catalytic surfaces, and local pH variations due to CO 2 dissolution can be eliminated. However, compared to CO 2 RR in acidic solutions, the CO reduction reaction to C 2+ in acidic electrolytes has been little studied. In this work, we quantitatively study the CO reduction reaction (CORR) to C 2+ products in an acidic solution through experimental gaseous CO electrolysis and multiphysics simulation of the local pH. We used Cu nanoparticles (CuNPs) as catalysts, which are commonly used in CO 2 RR. CuNPs were synthesized using a chemical reduction method using NaBH 4 as the reductant. The oxidation state of copper nanoparticles is Cu(II), confirmed by XPS and XRD. A catalyst ink was prepared by dispersing 1.7 mg CuNPs in 2.2 μL 5 wt% Nafion solution and 600 μL iso-propanol. 80 μL ink was added dropwise onto the GDE. For CORR measurements, a home-made three-compartment electrochemical cell was employed. A solution of pH 2.0 (0.5 M H 3 PO 4 0.5 M KH 2 PO 4 1.5 M KCl) and pH 1.0 (1.0 M H 3 PO 4 2.0 M KCl) were used for the catholyte. Gas and liquids products were quantified by gas chromatography and 1 H-NMR, respectively. A reaction-diffusion model based on Nernst-Planck equation was used to simulate the local pH using COMSOL Multiphysics software. A one-dimensional model was used with a diffusion layer of 100 μm. For simplicity, only proton-consuming reactions were considered. Phosphate equilibrium reactions were introduced. Electrochemical CO reduction was performed in acidic solutions. Hydrogen evolution was dominant at low current densities (below 50 mA/cm 2 ) in both pH 1.0 and 2.0 solutions. The C 2+ production became dominant at 200 mA/cm 2 , and its faradaic efficiency was almost equivalent to that of neutral and alkaline solutions. We assumed that the suppression of hydrogen evolution was due to the increase in pH at the electrode surface with increasing current density. Therefore, we calculated the local pH by multiphysics simulation. The surface pH suddenly increased to about 13 at 200 mA/cm 2 at pH 2.0. Taking into account these results, the selectivity of C 2+ increased with increasing pH on the electrode surface. At the conference, we will also present the effect of surface cations on CORR. References [1] A. Inoue, T. Harada, S. Nakanishi, K. Kamiya, EES Catal. , 2023 , 1, 9 [2] K. Kamiya, K. Fujii, M. Sugiyama, S. Nakanishi, Chem Lett. , 2021 , 50, 166-179 [3] Gu. J., Liu. S., Ni. W., Ren. W., Haussener. S., Hu. X., Nat.Catal., 2022 , 5, 268–276 [4] J. E. Huang, F. Li, A. Ozden, A. S. Rasouli, F. P. G. de Arquer, S. Liu, S. Zhang, M. Luo, X. Wang, Y. Lum, Y. Xu, K. Bertens, R. K. Miao, C. T. Dinh, D. Sinton and E. H. Sargent, Science , 2021 , 372, 1074 -1078 Figure 1

Using pH dependence for understanding mechanisms in electrochemical CO reduction

Unraveling the rate-determining step of C2+ products during electrochemical CO reduction

Understanding Trends in Electrochemical Carbon Dioxide Reduction Rates

Reaction Mechanisms for the Electrochemical Reduction of CO_2 on the Cu(100) Surface from Quantum Mechanics Free Energy Calculations with Explicit Water

Elucidating the Proton Source for CO2 Electro-reduction on Cu(100) using Many-body Perturbation Theory

Ph Effects on the Electrochemical Reduction of CO(2) Towards C2 Products on Stepped Copper

Thermodynamic and Kinetic Competition between C–H and O–H Bond Formation Pathways during Electrochemical Reduction of CO on Copper Electrodes

Investigating CO2 electro-reduction mechanisms: DFT insight into earth-abundant Mn diimine catalysts for CO2 conversions over hydrogen evolution reaction, feasibility, and selectivity considerations

Free-Energy Barriers and Reaction Mechanisms for the Electrochemical Reduction of CO on the Cu(100) Surface, Including Multiple Layers of Explicit Solvent at Ph 0.

Reaction Mechanisms for the Electrochemical Reduction of CO2 to CO and Formate on the Cu(100) Surface at 298 K from Quantum Mechanics Free Energy Calculations with Explicit Water

Electrokinetic and in Situ Spectroscopic Investigations of CO Electrochemical Reduction on Copper.

Direct Low Concentration CO2 Electroreduction to Multicarbon Products Via Rate-Determining Step Tuning

Structure- and Potential-Dependent Cation Effects on CO Reduction at Copper Single-Crystal Electrodes

Mechanistic Implications of Low CO Coverage on Cu in the Electrochemical CO and CO2 Reduction Reactions

Electrochemical Gaseous Carbon Monoxide Reduction Using Cu Nanoparticles in Acidic Electrolytes

Selectivity of Electrochemical CO 2 Reduction on Metal Electrodes: The Role of the Surface Oxidized Layer

From Electricity to Fuels: Descriptors for C1 Selectivity in Electrochemical CO2 Reduction

Molecular-Scale Insights into Electrochemical Reduction of CO 2 on Hydrophobically Modified Cu Surfaces

Molecular-Scale Insights into Electrochemical Reduction of CO2 on Hydrophobically Modified Cu Surfaces.

Full atomistic reaction mechanism with kinetics for CO reduction on Cu(100) from ab initio molecular dynamics free-energy calculations at 298 K