Abstract:High-speed sliding often leads to catastrophic landslides, many of which, in the initial sliding phase before disintegration, experience a friction-induced thermal pressurization effect in the bottom shear band, accelerating the movement of the overlying sliding mass. To quantitatively investigate this complex multiphysical phenomenon, we established a set of equations that describe the variations in temperature and excess pore pressure within the shear band, as well as the conservation of momentum equation for the overlying sliding mass. With a simplified landslide model, we investigated the variations of temperature and excess pore pressure within the shear band and their impacts on the velocity of the overlying sliding mass. On this basis, we studied the impact of seven key parameters on the maximum temperature and excess pore pressure in the shear band, as well as the impact on the velocity of the overlying sliding mass. The simulation results of the standard model show that the temperature and excess pore pressure in the shear band are significantly higher than those in the adjacent areas, and reach the maximum values in the center. Within a few seconds after the start, the maximum excess pore pressure in the shear zone is close to the initial stress, and the shear strength loss rate exceeds 90%. The thermal pressurization mechanism significantly increases the velocity of the overlying sliding mass. The results of parameter sensitivity analysis show that the thermal expansion coefficient has the most significant impact on the temperature and excess pore pressure in the shear band, and the sliding surface dip angle has the most significant impact on the velocity of the overlying sliding mass. The results of this study are of great significance for clarifying the mechanism of thermal pressurization-induced high-speed sliding.

A new numerical model of ring shear tester for shear band soil considering friction-induced thermal pressurization

Numerical investigation of friction-heating-pressurization and its control parameters in the shear band of high-speed landslides

Study Of Surrounding Rock Damage Induced By Tunnel Boring Machine Driving Tunnel At West Route Of South To North Water Transfer Project

A Dynamic Approach of Frictional Heating and Thermal Pressurization in Landslides

Study of shear properties and shear model of soil-rock mixture

A thermo-poro-mechanical model for catastrophic landslides under unsaturated conditions

Shear characteristics of interface based on subloading-friction model

MPM simulation of frictional heating–induced hypermobility of landslides

Development of a shear strength model for a rock mass containing a complex fracture system based on direct shear tests: a case study

A dynamic model for rapid startup of high-speed landslides based on the mechanism of friction-induced thermal pressurization considering vaporization

On Frictional Heating and Pore Pressure Generation:Implications for Coseismic Landslides Hypermobility

Residual state rate effects of shear-zone soil regulating slow-to-fast transition of catastrophic landslides

Dynamic Simulation and Analysis of High-Speed and Long Run-Out Landslide Triggered by the Wenchuan Earthquake, China

Experimental and Numerical Investigations of A Catastrophic Long-Runout Landslide in Zhenxiong, Yunnan, Southwestern China

THERMO-EFFECT ON HIGH-SPEED LANDSLIDE

Experimental and numerical study of shear strength on the slide zone soil by the coupling of seepage and shear test

Trigger mechanism of loess-mudstone landslides inferred from ring shear tests and numerical simulation

Influence of the thermal effect on quasi-static shear characteristics of calcareous soil: an experimental study

A thermo-mechanical model for saturated and unsaturated soil-structure interfaces

Influence of Stress Conditions on Shear Behavior of Slip Zone Soil in Ring Shear Test: an Experimental Study and Numerical Simulation

Application of a novel constitutive model to evaluate the shear deformation of discontinuity