Abstract:Rapid industrialization and urbanization have brought a severe problem of energy shortage and environmental pollution into our life. As the fourth-largest energy, Nowadays,Lignocellulosic biomass is increasingly regarded as an eco-friendly renewable feedstock for producing various bio-based products. Recently, hydrothermal carbonization (HTC) as a hot topic has attracted a great deal of attention because the process requirements of HTC are comparably low and are able to treat wet feedstock without an energy extensive drying process. But so far, some literatures have focused on the morphology, chemical structure and adsorption capacity of hydrochar, etc. Only few reports have provided a detailed description on the kinetic analysis of hydrochar. Pyrolysis is considered as the first step of the process of gasification, liquefaction, carbonization, and combustion. On the other side, the knowledge of the pyrolysis kinetics is fundament for predicting the pyrolysis behavior of materials and the design of the suitable reactor. In this study, pine sawdust was provided by a factory in Anhui province in 2015. The hydrochar was hydrothermally obtained from 5 g of sawdust immersed in 40 mL of distilled water in the stainless steel autoclave keeping temperature at 200℃ for 6 h, then as-prepared hydrochar was dried in an oven at 105℃ for 24 h. Pyrolysis characteristics and organic structure of both pine sawdust and hydrochar were investigated via thermogravimetric analysis and Fourier transformation infrared spectrometer, respectively. Different heating rates (10, 20, 30℃/min) were chosen to study the influence of pyrolysis process. Meanwhile, the distributed activation energy model (DAEM) was used to study the pyrolysis kinetics by means of the relation between conversion rate and activation energy. The results indicated that : 1) Compared with pine sawdust organic structure of hydrochar treated by hydrothermal carbonization process was changed, and the organic function groups of pine sawdust and hydrochar decreased in the different ways with the increase of pyrolysis temperature, but the organic function groups of hydrochar decreased faster than pine sawdust's when the temperature was over 200℃; 2) Thermogravimetric curves showed that hydrochar needed higher temperature and led to the faster loss weight rates than pine sawdust during the pyrolysis process, but the trend of thermogravimetric curves of both products changing with heating rates was same; 3) The values of pyrolysis activation energies of hydrochar and pine sawdust were different ranging within 99.33-252.72 and 63.77-211.68 kJ/mol, respectively. But the trends of the pyrolysis activation energies of hydrochar and pine sawdust were very similar with the increment of conversion rate. In summary, hydrothermal treatment process destroyed organic functional groups and lowered volatile content of pine sawdust, resulting in the changes of pyrolysis characteristics. Specifically, the whole pyrolysis process shifted to higher temperature, the reaction rate was accelerated and the main pyrolysis process occurred in a narrower temperature range shortening the pyrolysis time. Activation energy also was influenced due to the hydrothermal process, leading the reduction of the values at the dominating stage of volatile loss, however, the increase of the values at the initial and final stage of volatile loss. This study provides reference for pyrolysis and mechanism of hydrochar production.

Biochar characteristics produced via hydrothermal carbonization and torrefaction of peat and sawdust

Hydrothermal Carbonization of Agricultural Biomass: Characterization of Hydrochar for Energy Production

FEATURE RESEARCH OF HYDROTHERMAL BIOCHAR FROM SAWDUST

Physicochemical, Pyrolytic, and Combustion Characteristics of Hydrochar Obtained by Hydrothermal Carbonization of Biomass

Biochars from Post-Production Biomass and Waste from Wood Management: Analysis of Carbonization Products

Thermal Properties of Biochars Derived from Waste Biomass Generated by Agricultural and Forestry Sectors

Comparison of pyrolysis characteristics and kinetics of sawdust and its hydrochar

Production and characterization of slow pyrolysis biochar: influence of feedstock type and pyrolysis conditions

Biochar as an Exceptional Bioresource for Energy, Agronomy, Carbon Sequestration, Activated Carbon and Specialty Materials

Hydrothermal Carbonization and Torrefaction of Kenaf, Rice Husk, Corncob, and Wood Chip: Characteristics and Differences of Hydrochar and Torrefied Char

Thermogravimetric, thermochemical, and infrared spectral characterization of feedstocks and biochar derived at different pyrolysis temperatures

The Effect of Pyrolysis Temperature and the Source Biomass on the Properties of Biochar Produced for the Agronomical Applications as the Soil Conditioner

The composition, energy, and carbon stability characteristics of biochars derived from thermo-conversion of biomass in air-limitation, CO2, and N2 at different temperatures

CO 2 gasification of biochar derived from conventional and 1 microwave pyrolysis 2

Actual Trends in the Usability of Biochar as a High-Value Product of Biomass Obtained through Pyrolysis

Physico-chemical characterization of biochar derived from different raw materials

Effect of wet torrefaction on the physicochemical characteristics and gasification behavior of biochar

Chemical characterization of biochar and assessment of the nutrient dynamics by means of preliminary plant growth tests

Biochar physicochemical properties: pyrolysis temperature and feedstock kind effects

Properties of biochar derived from wood and high-nutrient biomasses with the aim of agronomic and environmental benefits

In-depth Comparison of the Physicochemical Characteristics of Bio-Char Derived from Biomass Pseudo Components: Hemicellulose, Cellulose, and Lignin