Abstract:The effects of substrate temperature and O-2 flux on structural, electrical, and optical properties of the films prepared by RF reactive magnetron sputtering with SnF2-Sn target have been investigated by X-ray diffraction (XRD), Hall effect measurements, optical transmission spectra, and photoluminescence (PL) spectra. It is found that F-doped SnO films are produced and exhibit amorphous structure at lower O-2 fluxes for substrate temperature of RT-300 degrees C, and window of O2 flux for depositing the films is reduced as substrate temperature increases. F-doped SnO2 (FTO) films are formed at higher O-2 fluxes, and they exhibit amorphous state at substrate temperature of RT but crystalline state at substrate temperature of 150 and 300 degrees C. Furthermore, increasing O-2 flux or substrate temperature can promote crystallinity and affect growth orientation for crystalline FTO films. Highly conductive FTO films can be obtained only at suitable O-2 fluxes and higher substrate temperatures (150 and 300 degrees C), at which the films keep crystalline SnO2 structure along with high amount of oxygen vacancy (V-O). Increasing substrate temperature from 150 to 300 degrees C, the resistivity of FTO films cannot be further decreased due to the out-diffusion of F although the film crystallinity improves. Compared with F-doped SnO films, the average transmittance in visible light range and band gap (E-g) of FTO films obviously increase. The FTO films show similar shaped PL spectra that can be attributed to substitutional fluorine (F-O) and V-O defects in the films, and PL emission intensity increases with increasing O-2 flux or substrate temperature due to the improvement of film crystallinity. It is observed that the PL emission characteristics (shape and intensity) of F-doped SnO film are obviously different from FTO films and they have great changes as substrate temperature from RT to 150 degrees C, but corresponding mechanisms need to further clarify. (C) 2017 Elsevier B.V. All rights reserved.

Optoelectronic Properties of Fluorine and Cobalt Co-Doped Tin Oxide Thin Films Deposited by Chemical Spray Pyrolysis

Abnormal Behaviors in Electrical Transport Properties of Cobalt-Doped Tin Oxide Thin Films

Transparent P-Type Conducting Indium-Doped SnO2 Thin Films Deposited by Spray Pyrolysis

P-type Transparent Conducting Indium-Tin Oxide Thin Films Deposited by Spray-pyrolysis

Structural, Optical, Electrical, and Nanomechanical Properties of F-Doped Sno2 Fabricated by Ultrasonic Spray Pyrolysis

Effect of the fluorine content on the structural and electrical properties of SnO2 and ZnO–SnO2 thin films prepared by spray pyrolysis

Investigation of the Structural, Optical and Electrical Properties of Zinc Oxide Co-Doped with Fluorine and Cobalt

Spray pyrolyzed surface-modified ZnO thin films via cobalt doping: Optical, structural and morphological properties

Effect of very low to high Sb-doping on the structural, electrical, photo-conductive and thermoelectric properties of fluorine-doped SnO2 (FTO) thin films prepared by spray pyrolysis technique

Transparent conductive F-doped SnO 2 films prepared by RF reactive magnetron sputtering at low substrate temperature

Structural, Electrical, and Optical Properties of F-doped SnO or SnO2 Films Prepared by RF Reactive Magnetron Sputtering at Different Substrate Temperatures and O2 Fluxes

Properties of Fluorine-Doped SnO2 Thin Films by a Green Sol–gel Method

Structural, Morphological and Optical Characterization of Tin Doped Zinc Oxide Thin Film by (SPT)

Sputtering deposition of transparent conductive F-doped SnO2 (FTO) thin films in hydrogen-containing atmosphere

Properties of fluorine-doped tin oxide films produced by atmospheric pressure chemical vapor deposition from tetramethyltin, bromotrifluoromethane and oxygen

Preparation and characterization of graphene-based fluorine doped tin dioxide thin films via spray pyrolysis technique

Investigation of Photocatalytic and Low-Emissivity Properties of TiO 2 :F Films Featuring Columnar Structure Prepared on SnO 2 :F Substrate by Sol–gel Method

Nanomechanical and Material Properties of Fluorine-Doped Tin Oxide Thin Films Prepared by Ultrasonic Spray Pyrolysis: Effects of F-Doping

Optoelectronic properties of fluorine and antimony-doped tin dioxide nanoparticles.

Investigation On Structural, Electrical And Optical Properties Of Tungsten-Doped Tin Oxide Thin Films