Abstract:With the implementation of China’s Green Fence Policy and the following National Sword Policy, there is a need to divert previously accepted waste materials away from the landfill. Mixed plastic and paper wastes that are too contaminated to be economically recycled can be used for conversion into fuels and products. The effect of common contaminants present in waste streams must be determined to make municipal solid waste (MSW) a viable alternative to agricultural feedstocks for conversion. In this study, MSW was sourced from a dual stream materials recovery facility (MRF) in Emmet County, Michigan and characterized via mass balance. The most common contaminants in mixed paper and plastic were quantified and targeted for decontamination when mixed paper was explored for low temperature conversion pathways and plastics for high temperature conversion pathways. Ink, stickies, and plastic contamination were sorted out of the mixed paper stream and did not have an impact on sugar yields during enzymatic hydrolysis (EH). Although no improvement in yield was found, it was noted that copy paper within the mixed paper stream had an elevated pH and higher concentration of fermentation inhibitors, suggesting that intrinsic properties of some paper types may not be ideal for EH and fermentation conversion. Dilute alkaline pretreatment and mechanical refining of mixed paper increased the EH yield of mixed paper, suggesting this previously established process could be used as a decontamination method. “Dirt” and particulates were washed from mixed plastic using either an aqueous detergent or a non-aqueous chemical washing method. Liquid oil yields were increased during microwave assisted fast pyrolysis. All decontamination techniques met the cost target of less than $30/dry ton with plastic decontamination ranging from $18.16 to $24.81/dry ton. Because dilute alkaline pre-treatment and mechanical refining is considered part of the conversion process, the decontamination cost during feedstock preprocessing was considered $0/dry ton.

Wet-mechanical processing of a plastic-rich two-dimensional-fraction from mixed wastes for chemical recycling

Chemical Recycling of Polyolefin Waste: from the Perspective of Efficient Pyrolysis Reactors

Separation and Characterization of Plastic Waste Packaging Contaminated with Food Residues

Closed-loop recycling of polyethylene-like materials

Stepwise flotation separation of WEEE plastics by polymeric aluminum chloride towards source control of microplastics

Mechanochemical Pre-Treatment for Viable Recycling of Plastic Waste Containing Haloorganics

Impacts of washing and deodorization treatment on packaging-sourced post-consumer polypropylene

Experimental Investigation of the Productivity of a Wet Separation Process of Traditional and Bio-Plastics

Chemical Recycling of Mixed Plastics in Electronic Waste Using Solvent-Based Processing

Hybrid Chemomechanical Plastics Recycling: Solvent-free, High-Speed Reactive Extrusion of Low-Density Polyethylene

Chemical Recycling of Mixed Polyolefin Post-Consumer Plastic Waste Sorting Residues (MPO323)—Auto-Catalytic Reforming and Decontamination with Pyrolysis Char as an Active Material

Quality evaluation and economic assessment of an improved mechanical recycling process for post-consumer flexible plastics

Morphological analysis of mechanically recycled blends of high density polyethylene and polypropylene with strong difference in melt flow index

Dry cleaning process and mechanism of gas–solid fluidized bed for waste film plastics

Chemical recycling of polyolefins: a closed-loop cycle of waste to olefins

Sustainable chemical upcycling of waste polyolefins by heterogeneous catalysis

The role of chemical and solvent-based recycling within a sustainable circular economy for plastics

Waste Plastics Chemical Recycling in the Context of Refining and Petrochemical Industries

Recycling of Pretreated Polyolefin-Based Ocean-Bound Plastic Waste by Incorporating Clay and Rubber

Decontamination of Mixed Paper and Plastic Municipal Solid Waste Increases Low and High Temperature Conversion Yields

Feasibility study on the production of low melt flow rate recycled polypropylene from postconsumer waste