Abstract:Residual stresses can have detrimental effect on the life cycle of engineering components and can affect the accuracy of the fatigue life prediction models. Accurate measurement of these stresses are therefore crucial. . However, destructive and semi-destructive methods of measuring residual stresses often cause damage to the components. In contrast, the non-destructive ultrasonic method allows for intact measurement of residual stresses even, in situation where portability is not feasible. Various waves can be utilized in the ultrasonic method for measuring residual stresses. In this study, longitudinal critically refracted (LCR) waves were employed due to their higher sensitivity, larger scanning area, and lower sensitivity to texture effect, making them preferable over other waves. The purpose of this study was to investigate the influence of plasticity on the measurement of residual stresses using the ultrasonic method. To achieve this, two stainless steel disks were subjected to quenching at temperatures of 300 °C and 700 °C to induce different levels of residual stresses and plasticity. The material properties of the disks were determined through standard tensile tests to facilitate numerical simulations. Tensile test specimens were extracted from the initial sheet to measure the yield stress and modulus of elasticity. The coefficient of acoustoelasticity, was determined by subjecting the tensile test specimens to different stress levels and recording the wave flight time. The coefficient of acoustoelasticity for stainless steel 316Lwas obtained using the slope of and (E(t-t0))/t0,. Residual stresses were experimentally measured using both the ultrasonic method and the center-hole drilling method, and the results were compared with those obtained from numerical analyses. The findings from center-hole drilling method, ultrasonic method, and numerical simulation were then compared and discussed. Different levels of plasticity were considered, and the accuracy of measuring residual stresses was analyzed and evaluated.

Neutron Diffraction Research of Residual Stress in Metal Plates Deposited on Rigid Substrate by DLMD Method

Study on Measurement Method of Interior Stress Distributions in Engineering Rolled-Plates

Neutron diffraction methods for the study of residual stress fields

Diffraction-Based Residual Stress Characterization in Laser Additive Manufacturing of Metals

Spatial Distribution Evolution of Residual Stress and Microstructure in Laser-Peen-Formed Plates

Neutron diffraction residual stress analysis and mechanical properties of additively manufactured high strength steel hollow sections

Recent Progress Of Residual Stress Distribution And Structural Evolution In Materials And Components By Neutron Diffraction Measurement At Rsnd

Residual Stress Mapping in Heat-Assisted Additive Manufacturing of IN 718: An X-Ray Diffraction Study

Operando neutron diffraction reveals mechanisms for controlled strain evolution in 3D printing

A study on the effect of plasticity on the measurement of residual stresses using ultrasound technique

Residual Stress in Cold Spray SS304L Measured Via Neutron Diffraction and Comparison of Analytical Models to Predict the Residual Stress

Residual Stress Analysis of Additive Manufactured A356.2 Aluminum Alloys using X-Ray Diffraction Methods

Residual Stress Distribution in Selective Laser Melting of SS316L Parts

Texture-based residual stress analysis of laser powder bed fused Inconel 718 parts

NDT of Residual Stress in Thick Aluminum Alloy Plates under Different Aging Conditions Using Multiple Techniques

Neutron Diffraction Residual Stress Study of a AA2219-T87 Self-Reacting Friction Stir Weld

Analytical Modeling of Residual Stress in Laser Powder Bed Fusion Considering Part’s Boundary Condition

Geometrical effects on residual stress in selective laser melting

In situ measurements and simulation of residual stresses and deformations in additively manufactured thin plates

Prediction of Residual Stress Random Fields for Selective Laser Melted A357 Aluminum Alloy Subjected to Laser Shock Peening

Neutron diffraction residual stress determinations in titanium aluminide component fabricated using the twin wire-arc additive manufacturing