Abstract:Reaction between aluminum and water offers a simple way for hydrogen generation. However, the passive oxide film subsequently formed on Al would become a major obstacle for its continuous reaction. Gallium was proved to be an effective way to remove the passive oxide film through penetrating into Al granules, which fosters the reaction between Al and water. However, fabrications of Al–Ga alloy so far are generally highly time and energy consuming. Here, unlike the existing strategies of using solid state Al-rich alloys for the reaction system, the liquid phase alloy was introduced and prepared to develop an extremely simple source for hydrogen generation where the mass percentage of Al can be less than 1%. Such conceptual innovation would help maintain the alloy in liquid state which thus allows for rather convenient operation. To probe into the methodology, the dynamic hydrogen generation phenomenon of such Al-fed liquid phase GaIn alloy inside NaOH electrolyte was disclosed. According to the experimental observations, the hydrogen was generated mainly at the interface between the liquid metal and the Petri dish rather than the liquid metal-electrolyte interface. Homogenous hydrogen generation only takes place at the liquid–solid interface while heterogeneous hydrogen generation from the moving accumulated Al granules happens on all surfaces. The present finding is expected to open a new way towards low cost and straightforward hydrogen generation. It would also help better understand the mechanisms lying behind as well as the dynamic traveling behaviors of the aluminum powered gallium alloy machine.

Unveiling the role of indium and tin in Al–Ga based alloys for on-demand hydrogen supply from simulation to validation

Hydrogen production performance of an Al-Ga-In-Sn quaternary alloy

Development of Ti–Zr–Mn–Cr-(V–Fe) Based Alloys for Hydrogen Feeding System in Hydrogen Metallurgy Application

Sn-free Al-based on-demand hydrogen production materials for easy recycling

Effect of Different Cu Contents on the Microstructure and Hydrogen Production of Al–Cu-Ga-In-Sn Alloys for Dissolvable Materials

Influence of in and Sn Compositions on the Reactivity of Al–Ga–In–Sn Alloys with Water

Hydrolysis-Based Hydrogen Generation Investigation of Aluminum System Adding Low-Melting Metals

Preparation of Al-3Ga-3In-3Sn Alloy Powder by Coupling Alloying and Ball Milling and Its Application on High-Rate Hydrogen Generation at Room Temperature

Hydrogen production via hydrolysis of Al-eutectic GaInSn composites

Dynamic hydrogen generation phenomenon of aluminum fed liquid phase Ga–In alloy inside NaOH electrolyte

Al-water Reactivity of Al-Mg-Ga-In-Sn Alloys Used for Hydraulic Fracturing Tools

Comparative Study on Activation of Aluminum with Four Liquid Metals to Generate Hydrogen in Alkaline Solution

The Role of Microstructural Length Scale in Hydrogen Generation Features of an Al-Sn-Fe Alloy

Metal Substrate Enhanced Hydrogen Production of Aluminum Fed Liquid Phase Ga–In Alloy Inside Aqueous Solution

Hydrogen generation by the hydrolysis of mechanochemically activated aluminum-tin-indium composites in pure water

Tailoring the hydrogen production behavior of Al-Zn-Sn alloys through their as-solidified microstructures

Hydrogen trapping and embrittlement in high-strength Al-alloys

Effect of Mg on Plasticity and Microstructure of Al-Mg-Ga-Sn-In Soluble Aluminum Alloy

Effects of Preparation Method on the Hydrolytic Hydrogen Production Performance of Al-rich Alloys

Instant Hydrogen Production Using Ga-In-Sn-Bi Alloy-Activated Al-water Reaction for Hydrogen Fuel Cells

Effect of Composition on the Reactivity of Al-rich Alloys with Water