Synthesis and properties of bio-based thermoplastic poly(ether urethane) for soft actuators

Yang Sook Jung,Jeongjae Woo,Eunsol Lee,Sunhee Lee,Eun Joo Shin

DOI: https://doi.org/10.1007/s10965-022-03375-x

IF: 3.061

2022-11-26

Journal of Polymer Research

Abstract:In this study, bio-based thermoplastic polyurethane (TPU) for use in soft actuators is bio-based poly(ether-urethane) made using fermented corn, along with bio-derived compounds such as propane-1,3-diol (PDO) as a chain extender. Bio-based TPUs were obtained through a solvent-free one-shot synthesis method, and the effects of varying the [NCO]/[OH] molar ratio and type of isocyanates on chemical structure, thermal stability, and mechanical properties were investigated. The degree of phase separation (DPS) and state of hard segment (HS) / soft segment (SS) of TPU are important factors affecting the thermal and physical properties of the prepared film. These properties depend on the [NCO]/[OH] molar ratio and the type of isocyanates used for polymerization. The results showed that, when aromatic isocyanate was used, the degree of separation of the HS/SS was improved as the molar ratio increased. The average molecular weight and DPS as well as thermal and mechanical properties of 1-isocyanato-4-[(4-isocyanatophenyl)methyl]benzene (MDI)-based TPU samples are all higher than those of 1,1'-methylenebis(4-isocyanatocyclohexane) (H 12 MDI)-based TPU samples in spite of the lower HS content. These findings of this study are expected to contribute to the preparation of fused deposition modeling (FDM) 3D printing or 4D printing for shape memory polymer from bio-based TPU filaments for use in soft actuators with a shore hardness range of 59~84A.

polymer science