Abstract:Hot-dip galvanizing is the most economical way to improve the corrosion resistance of advanced high strength automobile steel. With the high trend of developing of automobile steel towards light-weight and high-strength, the contents of Si, Mn, Al alloy elements in steel increase accordingly. These alloy elements would be selectively oxidized during hot-dip galvanizing process, which affect in turn the wettability of steel surface and form different interface microstructures. However, its effect on the mechanical behavior of steel has never been known as clear as desired. Base on this point, the thermodynamics of the surface oxide and its effect on the interface microstructure of three high-strength automobile steels were studied after the same hot-dip galvanizing treatment as well as their tensile fracture behavior under different deformation conditions was in situ analyzed. Combined with the microstructure analysis and thermodynamic calculation, it can be concluded that different compositions of steel would produce different kinds of oxide on its surface. When Mn2SiO4 and SiO2 were formed as thermodynamic stable phases, it was difficult to form a continuous Fe2Al5Zn0.4 inhibition layer at the interface, zinc liquid could penetrate into the iron substrate and then form the brittle phase zeta-FeZn13, where the crack was easily to be obtained and expanded to the substrate, resulting in the decrease of mechanical properties. When MnO and Mn2SiO4 with a small amount were formed as thermodynamic stable phase, the Fe2Al5Zn0.4 inhibition layer can be obtained. Under the tensile stress, this crack generated at the interface and extended to the zinc layer. So, the fracture of the experimental steel was mainly resulted from the failure of substrate. When MnO and FeO were formed as metastable phase, Fe, as formed by aluminothermic reduction during hot-dip galvanizing, would reacted with zinc liquid to form Gamma-Fe11Zn40 phase in the zinc layer. The crack generated under the tensile stress and expanded in the zinc layer. Since the unreduced MnO layer at the interface exhibited a higher bonding strength with substrate, tensile fracture of the experimental steel was caused by the failure of substrate.

Effect of Annealing Time on Coating Microstructure, Frictional and Electrochemical Behavior of Galvannealed Interstitial-Free Steel

Effect of Annealing on Microstructure and Corrosion Behavior of Interstitial Free Steel

Influence Of Annealing Temperature On Film Morphology And Tribological Performance Of Tisin-Ag Coating

Zn Diffusion and α -Fe(Zn) Layer Growth During Annealing of Zn-Coated B Steel

Effects of Alloying Elements on Surface Oxides of Hot-Dip Galvanized Press Hardened Steel

Effects of Annealing Treatment on Microstructure and Electrochemical Performances of Co-free MlNi4.0Al0.3Si0.1Fe0.6 Hydrogen Storage Alloy

Effect of Strip Entry Temperature on the Formation of Interfacial Layer During Hot-Dip Galvanizing of Press-Hardened Steel

Effect of Dipping Time on Microstructure and Properties of Zn-1Al-2Mg Coating by Hot-Dipping Galvanizing

Effect of the Interface Microstructure of Hot-Dip Galvanizing High-Strength Automobile Steel on Its Tensile Fracture Behaviors

Effect of annealing on the microstructure, mechanical properties and intergranular corrosion of a novel Al‐Mg‐Zn alloy

Effects of Microstructure and Texture on the Formability Character of the Coatings in Three Industrial Galvannealed Steels

Impact of cooling rates on the microstructure and cracking susceptibility of hot-dip galvanized Zn-12 wt% Al-5 wt% Mg coatings

Effect of Annealing Time on Microstructure Stability and Mechanical Behavior of Ferrite-Cementite Steel with Multiscale Lamellar Structure

Corrosion Properties of Steel Sheet with Zinc-base Alloyed Coatings

Impact of Copper, Tin and Titanium Addition on Bending-Induced Damage of Intermetallic Phases in Hot Dip Galvanizing

Effect of Sn Addition, Process Atmosphere pO2, and Annealing Time on the Selective Oxidation of a C-2Mn-1.7Si (Wt Pct) Advanced High-Strength Steel During Continuous Galvanizing

Characterization of hot-dip galvanized coating on dual phase steels

Effects of Zinc Bath Temperature on Microstructure of Hot Dip Galvanized 0.49%si Reactive Steel

Growth and Annealing of Zn-Mg Alloy Thick Films on Steel

Influence of Different Heat Treatment Temperatures on the Microstructure, Corrosion, and Mechanical Properties Behavior of Fe-Based Amorphous/Nanocrystalline Coatings

Effect of annealing time on microstructure and mechanical properties of Fe–C–Mn–Al–Si steel