Effect of cryogenic cooling on deformation of milled thin-walled titanium alloy parts

Fengbiao Wang,Yongqing Wang

DOI: https://doi.org/10.1007/s00170-022-10137-y

2022-09-17

Abstract:The thin-walled titanium alloy parts have the poor structural stiffness, and the surface deformation error can hardly be improved under heavy processing load, so that has poor machinability for this kind of materials. Based on the comprehensive investigation, liquid nitrogen (LN 2 ) cooling can change obviously the mechanical properties of alloy materials and reduce greatly the cutting heat, and it has been widely used in difficult-to-process materials. In this paper, the deflection and angle models of cutting deformation of titanium alloy thin-walled parts were established. A series of machining experiments were conducted using LN 2 and traditional flood cooling strategies, and the influence of milling temperature on machining deformation was analyzed. The results show that the deflection and angle of machining deformation are mainly related to milling force and elastic modulus. When the cooling temperature is reached −130 °C, there are few burrs on the machined surface. The brittle chip fracture is realized for cutting thin-walled parts, the milling force is increased, and the machining error is decreased clearly. Meanwhile, the location of the occurred deflection and angle has risen significantly near 10 mm, and the machining deformation is reduced obviously compared to the flood cooling. In cryogenic cooling, the increase of cutting stiffness, the change of chip breaking form, and the reduction of deflection are the main reasons for the improvement of thin-walled milling deformation defects. Furthermore, the cryogenic cooling strategy can effectively improve the deformation problem and obtain better machinability for the thin-walled titanium alloy parts.

engineering, manufacturing,automation & control systems