Abstract:The steel, whose nominal yielding strength f(y) is greater than or equal to 460 MPa, is generally referred to as high strength steel (HSS). Through the comparison with conventional strength steel (CSS) members, HSS members are more vulnerable to local buckling since the component plates are usually designed to be more slender in order to exploit higher material strength. The different mechanical properties between HSS and CSS, including yielding strength, ductility and so on, may lead to different local buckling behavior of steel members. However, little guidance is applicable in existing standards for the stability design of HSS members. In this paper, elaborate finite element (FE) models of HSS welded I-section beams under the loading conditions of uniform moment (four-point loading) and moment gradient (three-point loading) were developed by means of the general-purpose FE software package and validated against the available test results. Continuous lateral supports were ideally applied to restrict the occurrence of coupling with overall lateral-torsional buckling. Comprehensive parametric analyses on key parameters containing the plate width-to-thickness ratio and the steel material properties were further conducted, reflecting the influence of these parameters on the mechanical performance of local stability. Through this work, the variation rules on rotation capacity and postbuckling resistance of HSS welded I-section beams with plate width-to-thickness ratio and steel nominal yielding strength were clarified. Taking into account the interaction of local buckling modes between flanges and webs, new cross-section classification of HSS welded I-section beams was proposed based on the FE analysis results. After the introduction of the concept of interactive local slenderness, the design methods of postbuckling ultimate moment resistance for HSS welded I-section beams subjected to uniform moment and moment gradient were also proposed, which were assessed by comparing the design results with the ones obtained from the corresponding design approaches in Eurocode 3, ANSI/AISC 360-16 and GB 50017-2017. And the reliability of the new proposals was also confirmed by further statistical analysis.

Welded connections at high‐strength steel hollow section joints

Load-Carrying Capacity and Practical Calculation Method for Hollow Cylinder Joints Connected with H-Shaped Beams

Design Approach of Stiffeners in Extended End Plate Connections and Finite Element Analysis

Experimental and numerical study on compressive behavior of welded hollow spherical joints with external stiffeners

Design Of Concrete-Filled Steel Tubular Chs Connections In Tension

Load‐carrying capacity of MAG butt and fillet welded joints on high‐strength structural steels of grade S960QL and S960MC

02.05: Design of concrete-filled steel tubular longitudinal gusset plate connections

Equivalent Material Properties of the Heat-Affected Zone in Welded Cold-Formed Rectangular Hollow Section Connections

Experimental Investigation of Concrete-Filled Steel Tubular Longitudinal Gusset Plate Connections

Experimental Investigation and Design of Concrete-Filled Steel Tubular CHS Connections

Design for local buckling behaviour of welded high strength steel I-sections under bending

Load analyses of welded high-strength steel structures using image correlation and diffraction techniques

Postbuckling Resistance of High Strength Steel Welded I-section Beams Based on Interactive Slenderness

Local buckling behavior of high strength steel welded I-section flexural members under uniform moment:

Local buckling analysis of axially compressed welded box-section stub columns using Q420–Q960 steel

INVESTIGATION ON HIGH STRENGTH STEEL WELDED CONNECTIONS

Web crippling of stainless steel built-up I-sections under End-Two-Flange loading: Tests, simulations and design

IMPLEMENTATION OF LONGITUDINAL WELDING STRESSES INTO STRUCTURAL CALCULATION OF STEEL STRUCTURES

Load-carrying Capacity of High-Strength Steel Box-Sections I: Stub Columns

Study on the seismic behavior of connection via welding strengthening under load

Local Buckling Behavior of Welded Stub Columns with Normal and High Strength Steels