Abstract:This article investigates the performance of finite element model updating to identify the induced damage in a two-story reinforced concrete masonry-infilled building using vibration data as well as lidar (light detection and ranging) scans. The building, located in El Centro, California, was severely damaged due to the 2010 El Mayor–Cucapah (Baja California, Mexico) Earthquake, and it was planned to be demolished following a number of ambient and forced vibration tests. The forced vibration tests were performed using an eccentric mass shaker. During the testing sequence, damage was induced to the building by removing four exterior walls. The modal parameters of the structure are estimated using the ambient vibration and forced vibration measurements at the reference state and damaged state. Lidar data are also used to detect surface defects and quantify the temporal changes of surface defects caused by the wall removal and forced vibration tests. Based on site inspections, geometry measurements, and material test data, two initial finite element models are built, namely the un-tuned initial model and the tuned initial model. The tuned initial model implements stiffness reduction factors to account for the observed damage in the building at its reference state while the un-tuned model does not. Two sets of reference models are calibrated to represent the structure at the reference state using the un-tuned and tuned initial models. The reference models are then updated to fit the measured data at the damaged state of the building with damage being estimated as the loss of stiffness in updating substructures. The estimated damage is compared to the nominal value of induced damage and surface defects detected by lidar scans. The analysis of the results indicates that the un-tuned and tuned initial models provide similar updated models and damage identification results which are in good agreement with the nominal values of damage and lidar detection results.

Structural damage identification by a sensitivity-based finite element model updating method using transmissibility function data

Finite element model updating for structural damage detection using transmissibility data

Structural damage detection using a sensitivity-based model updating approach with autocorrelation function data

Experimental validation of an efficient strategy for FE model updating and damage identification in tubular structures

Structural damage identification of offshore wind turbines: A two‐step strategy via FE model updating

Structural Damage Identification Based on Transmissibility in Time Domain

Nonlinear finite element model updating with a decentralized approach

Structural modal identification and MCMC-based model updating by a Bayesian approach

Sensitivity-based model updating for structural damage identification using total variation regularization

Probabilistic identification of simulated damage on the Dowling Hall footbridge through Bayesian finite element model updating

Research on Finite Element Model Updating Technique Based on Static Strength Test

Flexibility sensitivity-based approaches for damage evaluation in jacket-platform structures

Structural Damage Identification Based on the Transmissibility Function and Support Vector Machine

A sensitivity-based nonlinear finite element model updating method for nonlinear engineering structures

Damage identification of structural systems by modal strain energy and an optimization-based iterative regularization method

Structural damage identification via physics-guided machine learning: a methodology integrating pattern recognition with finite element model updating

Time-Domain Finite Element Model Updating for Operational Monitoring and Damage Identification of Bridges

An application of finite element model updating for damage assessment of a two-story reinforced concrete building and comparison with lidar

Sensitivity Analysis Using a Reduced Finite Element Model for Structural Damage Identification

Finite Element Model Updating Using Evolutionary Strategy for Damage Detection

DAMAGE IDENTIFICATION OF CIVIL STRUCTURES BASED ON FINITE ELEMENT MODEL UPDATING