Abstract:This article investigates the performance of finite element model updating to identify the induced damage in a two-story reinforced concrete masonry-infilled building using vibration data as well as lidar (light detection and ranging) scans. The building, located in El Centro, California, was severely damaged due to the 2010 El Mayor–Cucapah (Baja California, Mexico) Earthquake, and it was planned to be demolished following a number of ambient and forced vibration tests. The forced vibration tests were performed using an eccentric mass shaker. During the testing sequence, damage was induced to the building by removing four exterior walls. The modal parameters of the structure are estimated using the ambient vibration and forced vibration measurements at the reference state and damaged state. Lidar data are also used to detect surface defects and quantify the temporal changes of surface defects caused by the wall removal and forced vibration tests. Based on site inspections, geometry measurements, and material test data, two initial finite element models are built, namely the un-tuned initial model and the tuned initial model. The tuned initial model implements stiffness reduction factors to account for the observed damage in the building at its reference state while the un-tuned model does not. Two sets of reference models are calibrated to represent the structure at the reference state using the un-tuned and tuned initial models. The reference models are then updated to fit the measured data at the damaged state of the building with damage being estimated as the loss of stiffness in updating substructures. The estimated damage is compared to the nominal value of induced damage and surface defects detected by lidar scans. The analysis of the results indicates that the un-tuned and tuned initial models provide similar updated models and damage identification results which are in good agreement with the nominal values of damage and lidar detection results.

Finite element model updating for structural damage detection using transmissibility data

Structural damage identification by a sensitivity-based finite element model updating method using transmissibility function data

Structural damage detection using a sensitivity-based model updating approach with autocorrelation function data

Nonlinear finite element model updating with a decentralized approach

Damage Identification in Warren Truss Bridges by Two Different Time–Frequency Algorithms

Experimental validation of an efficient strategy for FE model updating and damage identification in tubular structures

An application of finite element model updating for damage assessment of a two-story reinforced concrete building and comparison with lidar

Structural Damage Identification Based on Transmissibility in Time Domain

DAMAGE IDENTIFICATION OF CIVIL STRUCTURES BASED ON FINITE ELEMENT MODEL UPDATING

Time-Domain Finite Element Model Updating for Operational Monitoring and Damage Identification of Bridges

Damage detection in retaining wall structures through a finite element model updating approach

A Two-Stage Model Updating Method for the Linear Parts of Structures with Local Nonlinearities

Probabilistic identification of simulated damage on the Dowling Hall footbridge through Bayesian finite element model updating

A Substructure-based Model Updating Method to Damage Detection for Large-scale Structures

Vibration-based Bayesian model updating of an actual steel truss bridge subjected to incremental damage

Structural damage identification using system dynamic properties

Structural damage identification via physics-guided machine learning: a methodology integrating pattern recognition with finite element model updating

Damage Assessment Using The Energy Dissipation Ratio Of Acceleration Signals

Sensitivity-based model updating for structural damage identification using total variation regularization

Real-Time Structural Health Monitoring and Damage Identification Using Frequency Response Functions along with Finite Element Model Updating Technique

Famine Algorithm and Pseudo‐Kinetic Energy for Structural Damage Detection