Post‐Mortem Analysis of Building‐Integrated Flexible Thin Film Modules
Aldo Kingma,Helena Kirchner Sala,Leonard Simeonov,Rémi Aninat,Simona Villa,Klaas Bakker,Monique van den Nieuwenhof,Dorrit Roosen,Joris de Riet,Marc Koetse,Bart van de Vorst,Henk Steijvers,Mirjam Theelen
DOI: https://doi.org/10.1002/pip.3846
2024-10-09
Progress in Photovoltaics Research and Applications
Abstract:Corrugated rooftiles with integrated flexible thin film photovoltaic (PV) modules were investigated after three years of outdoor exposure to identify the main causes of performance loss. Significant degradation was found in many modules due to short circuit current loss and series resistance increase when comparing performance before and after outdoor installation. Through microscopic characterization of the cell material, four defect types could be identified, two of which were found mainly responsible for the observed degradation in performance. Flexible, lightweight thin film (TF) photovoltaic (PV) modules offer a unique opportunity for integration into non‐planar surfaces unable to support heavy weights. While such applications increase the potential for PV in urban areas, the reliability implications are yet to be investigated. Here, prototypes of corrugated rooftiles with integrated Cu (In,Ga)Se2 (CIGS) modules were investigated after 3 years of outdoor operation. Their performance before and after the outdoor exposure was compared and defects were localized. An unpackaging method was developed, allowing access to the solar cells for more detailed characterization of present defects without causing additional damage or changes to existing defects. To our knowledge, this was the first time such an unpackaging method was successfully applied to flexible TF PV modules. The relative efficiency loss ranged from 17% to 43%, mostly due to short‐circuit current (ISC) loss and series resistance (RS) increase. The predominant cause of the RS increase was the delamination at the interconnects, ascribed to thermomechanical stresses caused by outdoor temperature fluctuations. The ISC loss was mainly caused by localized delamination of CIGS from the molybdenum (Mo) back‐contact. The occurrence of such delaminated areas pointed to presence of high local stresses during outdoor operation, possibly due to thermal fluctuations, applied deformation and/or mechanical impact. Two other types of delamination defects were found with no observable impact on performance. These results show the necessity for further optimization in the material choice and processing of TF flexible modules, to avoid mechanical stress related failures upon integration into curved surfaces.
materials science, multidisciplinary,physics, applied,energy & fuels