Abstract:Continuous pressure put on researchers all over the world these days to design materials of improved properties create opportunities to study new methods of production in conjunction with entirely new and innovative materials such as alloys or composites. The authors in the current research manufactured aluminium reinforced with glass fibre (GF) using metallurgical synthesis, which is an unconventional and not sufficiently studied method of production. The composites with 1, 2 and 5 wt.% of glass fibre were produced with additional material obtained using consolidation of aluminium powder in extrusion process as reference material with 5 wt.% of glass fibre. All the materials were subjected to series of tests in order to determine their microstructure, density, electrical properties, hardness and susceptibility to plastic working in the compression test. It was found that glass fibre during metallurgical synthesis of aluminium composite partially melted and thus did not reinforce the material as well as during extrusion, which has been observed not only in the scanning electron microscope (SEM) and energy-dispersive X-ray (EDX) analysis but also in the analysis of macroscopic physical and mechanical properties. Based on the analysed samples, it may be stated that electrical conductivity of the samples obtained via metallurgical synthesis is higher than might be estimated on the basis of the rule of mixtures and glass fibre content and concerning the sample with 5 wt.% of GF is higher (32.1 MS/m) than of the reference material obtained in extrusion process (30.6 MS/m). Similar situation has been observed in terms of hardness of the tested samples where a minor increase in hardness was noticeable as the amount of glass fibre increased in the composites obtained by metallurgical synthesis. It is believed to be related to the melting of glass fibre, which reduced the volume fraction of GF containing mainly silicon oxides and their diffusion into the aluminium matrix, thus causing solid solution strengthening.

Fabrication and Characterization of Aluminum (Al-6061) Matrix Composite Reinforced with Waste Glass for Engineering Applications

MMCs with Controlled Non-Uniform Distribution of Submicrometre Al2O3particles in 6061 Aluminium Alloy Matrix

Investigation and Characterization of Novel Aluminium Matrix Composites Enhanced by Recycled Borosilicate Glass

Microstructural, physical and mechanical characterization of grinding sludge based aluminium metal matrix composite

Microstructure and mechanical behavior of metallic glass fiber-reinforced Al alloy matrix composites

Reinforcement of Aluminium-Matrix Composites with Glass Fibre by Metallurgical Synthesis

Investigation on Mechanical Properties of Agro and Industrial Waste Reinforcement in Aluminium 7075 Composite with Liquid Metal Stir Casting Route

Mechanical and metallurgical properties of a glass fiber-reinforced Al7075 hybrid composite produced by infiltration and after aging and abrasion

Microstructures and Mechanical Properties of Engineered Short Fibre Reinforced Aluminium Matrix Composites

Microstructure and Mechanical Properties of Aluminum Alloy Matrix Composites Reinforced with Fe-Based Metallic Glass Particles

Synthesis and characterization of spent alumina catalyst and grinding sludge reinforced aluminium-based composite material

Design of aluminum eco-composite for sustainable engineering application by the valorization of municipal wastes: Experimental and response surface analysis

Performance analysis and mechanical behavior of aluminum metal matrix composite

Microstructure and Mechanical Properties of High Strength Al2o3p/6061al Composites

Microstructure, Process Optimization, and Strength Response Modelling of Green-Aluminium-6061 Composite as Automobile Material

Effect of Synthetic Materials in Reinforcement of Aluminium Matrix Composites

E-glass fiber featured hybrid aluminium alloy composite: Metallographic, mechanical and fracture failure study

Mechanical Performance of glass/epoxy composites enhanced by micro- and nanosized aluminum particles

Investigation of mechanical and tribological behavior of composite material filled with black epoxy resin and aluminium tri-hydroxide using reinforcement of glass fiber

Tensile and Compressive Behaviour of Solid Glass Microspheres Reinforced LM13 Aluminum Alloy Based Metal Matrix Composites

Tensile and Fatigue Response of Alumina-Fiber-Reinforced Aluminum Matrix Composite