Abstract:The distress caused by alkali-silica reaction (ASR) to concrete structures can occur long time after the reaction has been triggered. We propose to use spectral induced polarization (SIP) as a non-destructive method for early detection of ASR reaction before the damage is apparent. Our research deals with monitoring the difference between the electrical behaviour (phase lag, bulk resistivity, relaxation time, total chargeability) of non-reactive (NR) and reactive (RC) concrete samples affected by ASR. Laboratory measurements of complex resistivity were done in the frequency range 1.43 mHz-20 kHz. A Debye decomposition (DD) model was used to determine the DC bulk resistivity (ρ0), and the distribution of the chargeability as a function of the relaxation time. The total chargeability (Σm) and the mean relaxation time (τmean) were computed as DD parameters to characterize the ASR development. While ρ0 was strongly dependent on the electrical conductivity of the solution (water, NaOH) with a constant change with time, both concrete mixtures saturated with the same solution showed an increase ρ0 due to the development of the matrix skeleton over time. In this work, ρ0 did not play a significant role to characterize the ASR development. For the samples affected by ASR, a significant evolution of Σm and τmean was found compared to the non-affected mixtures (RC, NRC-H2O), specially over the low frequency range [1.48 mHz < f < 5.86 Hz]. The RC-NaOH samples displayed a strong linear correlation between normalized chargeabilty and imaginary conductivity. This observation could be associated with an increase in surface conductivity of the Stern layer at reactive grain surface or the evolution of specific surface area due to production of ASR silica gel, or both. Based on our conceptual electrochemical model of RTD presented in this work, an evolution of chargeability peak was observed at relatively long relaxation time τ>102 s that could be associated with the polarization of aggregates affected by ASR.

Using of the Ultrasonic Method for Alkali-Silica Reaction Detection in the Cement Mortar

Comparison of Field Observations with Laboratory Test Results on Concretes Undergoing Alkali-Silica Reaction

Application of acoustic emission to monitoring the course of the alkali-silica reaction

ASSESSMENT OF ALKALI‐SILICA REACTION DAMAGE IN MORTARS WITH NONLINEAR ULTRASONIC TECHNIQUES

Alkali-silica reaction (ASR) detection in concrete from frequency dependent ultrasonic attenuation

Ultrasonic Coda Wave Monitoring of Alkali-Silica Reactivity in Concrete Laboratory Prisms

ALKALI SILICA REACTIVITY STUDY OF ACCELERATED MORTAR BAR BY MEANS OF ACOUSTIC EMISSION AND ULTRASONIC SOUNDING

RAPID ASSESSMENT OF ALKALI‐SILICA REACTION DAMAGE IN CEMENT MORTARS BY NONLINEAR ACOUSTIC TECHNIQUE

Wave mixing technique for nondestructive assessment of alkali-silica reaction damage in concrete prism samples

The use of computed tomography and scanning microscopy methods for assessing the alkaline reactivity of aggregate

Microscopic investigation of building materials affected by alkali-silica reaction

Experimental Identification of Alkali-Aggregate Reaction in Concrete

Monitoring of dielectric permittivity in accelerated alkali-silica reaction concrete with microwave backscattering

Monitoring accelerated alkali-silica reaction in concrete prisms with petrography and electrical conductivity measurements

Investigations on alkali-silica reaction products using Raman spectroscopy

Initial Characteristics of Alkali–Silica Reaction Products in Mortar Containing Low-Purity Calcined Clay

Evaluation of alkali–silica reaction damage in concrete by using acoustic emission signal features and damage rating index: damage monitoring on concrete prisms

Long-term ultrasonic monitoring of concrete affected by alkali-silica reaction

Dynamic elastic properties of hardened experimental mortar bars affected by accelerated alkali–silica reactivity test: a laboratory approach

Non-destructive non-invasive assessment of the development of alkali-silica reaction in concrete by spectral induced polarization: Evaluation of the complex electrical properties

Single-Impact Nonlinear Resonant Acoustic Spectroscopy for Monitoring the Progressive Alkali–Silica Reaction in Concrete