Abstract:The paper presents the results of investigation of the dislocation structure, the magnitude of the curvature–torsion of the crystal lattice, the amplitudes of the internal stress fields, as well as the redistribution of carbon atoms in zones of stable localization of deformations depending on the state of samples made of structural steel 20. Samples were studied without operation, after operation without destruction, and with destruction. The samples were stretched at the same speed until a stable deformation localization zone appeared, after which the loading was stopped. To study the dislocation structure, we used the method of transmission electron microscopy on thin foils. It has been shown that deformation of samples made of structural steel 20 in the direction "initial" → "not destroyed" → "destroyed" sample in all morphological components of the structure, as well as in the material as a whole, gradually leads to a fragmentation of the structure down to a nanocrystalline structure in individual areas of the material. Dislocations move to fragment boundaries, and the scalar dislocation density ρ decreases. At the same time, internal shear stresses σ s decrease. The change in local stresses σ l is of a different nature, namely, the plastic component of local stresses decreases, and the elastic component increases sharply. It has been established that deformation of steel 20 leads to the destruction of cementite particles located at the boundaries of dislocation fragments (the volume fraction decreases) and the formation of carbides inside the fragments (their volume fraction increases). Carbon from destroyed cementite particles at the boundaries of fragments is spent on the formation of cementite particles inside the fragments, of crystal lattice defects, and the formation of carbides in new morphological structures (micro- and nanograins).

Structural-Phase State and Fracture of a Low-Carbon Steel Coating

Microstructure Evolution and Failure Mechanism of Cr-coated Zry-4 in Air and Steam at 1200 °C

Microstructure and Corrosion Study on Friction Surfaced Aluminum Alloy Coatings over Mild Steel

Electron Microscopy of High-Speed Steel/30HGSA Steel Interface

Synthesis of Corrosion-Resistant Coatings by Non–Vacuum Electron Beam Surfacing: Production, Structure, and Properties

Study on Microstructure and Thermal Fatigue of FeMnCrAl/WC Coatings

Structure-fractal-property correlation of multiphase steel

Service Life Effect on Structure and Phase Composition of DIN 14MoV63 Steel

Structure-Phase State, Mechanical Properties, and Corrosion Behavior of Quasicrystalline AlCuFeSc Coating

Structure and Properties of Surfacing Made of High-Entropy High-Speed Steel

Microstructure and Wear Properties of Fe-based Amorphous/Nanocrystalline Coatings

Fracture toughness experimental investigations of metal structures from low-alloyed steel

Transition Zone Structure in the Fast-Cutting Surfaced Layer – Substrate System

Estimation of Structural Degradation of the Heat Affected Zone of the Welded Joint Under Fatigue

Study on the Self-Organization of an Fe-Mn-C-B Coating during Friction with Surface-Active Lubricant

Study of Dislocation Structure, Internal Stresses, and Redistribution of Carbon Atoms in the Zone of Localized Deformation in Structural Steel 20

Influence of an Electric Field on the Quench Aging of a Medium-Carbon Alloy Steel

Evaluation of Mechanisms for Strengthening of Surface Layers of Long Rails in Different Directions Under Continuous Operation

Operando Study of Structural Changes in High-Manganese Steel Under Dry Friction

Structure and High-Temperature Property of Amorphous Composite Coating Synthesized by Laser Cladding FeCrCoNiSiB High-Entropy Alloy Powder

Analysis on Microstructure of Graphite-like Composite Coating on Metal Substrate