PSA purification of waste hydrogen from ammonia plants to fuel cell grade
María Yáñez,Frederico Relvas,Alfredo Ortiz,Daniel Gorri,Adélio Mendes,Inmaculada Ortiz
DOI: https://doi.org/10.1016/j.seppur.2019.116334
IF: 8.6
2020-06-01
Separation and Purification Technology
Abstract:<p>Industrial hydrogen-rich waste streams hold promises in their upgrading to feed fuel cell stacks. As in the ammonia synthesis process, a stream of up to 180–240 Nm<sup>3</sup> per ton of ammonia is purged to keep the inert gases concentration below a threshold value; this stream contains large hydrogen quantities, which could be recovered. In the current work, a four-column PSA unit has been used to produce a high-purity hydrogen stream for fuel cell applications from a synthetic mixture with a molar composition of 58% H<sub>2</sub>, 25% N<sub>2</sub>, 15% CH<sub>4</sub> and 2% Ar, based on ammonia purge gas. Firstly, a comparative performance of four commercially adsorbents was accomplished to obtain the adsorption isotherms of H<sub>2</sub>, N<sub>2</sub>, CH<sub>4</sub>, and Ar, leading to the selection of 5A zeolite adsorbent. Then, the dynamic behavior of a packed bed was studied by single and multicomponent breakthrough experiments and simulated using Aspen Adsorption®. The results, simulations and experimental, indicate that after H<sub>2</sub> the first impurity to break thought the column is Ar, followed by N<sub>2</sub> and finally by CH<sub>4</sub>. Then, a design-of-experiments (DoE) methodology was used to select the best operating conditions of the experimental cyclic PSA unit to reach different target hydrogen product concentrations; the overall PSA performance was evaluated in terms of purity and recovery of H<sub>2</sub> product. According to the results, the four-column PSA unit running at 9 bar produced a stream with hydrogen concentration of 99.25% and 99.97% of H<sub>2</sub>, with a recovery of 75.3% and 55.5%, respectively, where the impurities were mostly Ar and N<sub>2</sub>. In addition to the technical performance, the economic assessment concluded that the cost to compress, transport and purify waste hydrogen to a concentration of 99.97% using a small-scale PSA unit from ammonia plants has been estimated in the range of 1.17–1.39 € kg H<sub>2</sub><sup>−1</sup>, depending on the dispensing pressure of 350 or 700 bar, respectively. These assessments offer a cost-effective solution to produce high-purity H<sub>2</sub> as low cost transportation, allowing hydrogen penetration into the mass markets.</p>
engineering, chemical