Comparing the Efficiency of Photocatalytic Humic Acid Destruction in Water with Oxygen and Hydrogen Peroxide on (N,Fe)-Doped Titanium Dioxide Samples in Different Irradiation Modes

Shvadchina, Yu. O.
DOI: https://doi.org/10.3103/S1063455X22030055
2022-07-19
Journal of Water Chemistry and Technology
Abstract:Titanium dioxide, one of the most important photocatalysts for the oxidation of compounds dissolved in water, is active only under ultraviolet irradiation and inactive in the visible spectral region due to its broad bandgap. A promising strategy for the creation of active TiO 2 samples able to efficiently utilize visible sunlight and thereby to essentially decrease the cost of the photocatalytic treatment of natural and waste water is the introduction of several dopants. The efficiency of nitrogen doped and nitrogen and iron ion codoped titania samples synthesized by the sol-gel method with a bandgap narrowed to 2.59–2.99 eV in the photocatalytic destruction of humic acid (HA) in water ( C = 55–60 mg/dm 3 ) with atmospheric oxygen and hydrogen peroxide was studied depending on pH and a radiation source: an SVD-120 mercury quartz lamp (λ > 200 nm) or a GE CMG70 metal halide lamp (λ > 360 nm). The efficiency of doped TiO 2 samples in the photocatalytic oxidation of aqueous HA solutions depended on the iron content (0–1% of Fe), the used oxidant, pH of the medium, and the irradiation mode. A much higher degree of HA destruction was attained in an acidic medium (pH 0 2.4) as compared to a neutral medium (pH 0 7) in both irradiation modes. The application of hydrogen peroxide increased the degree of photocatalytic HA mineralization in the presence of all the synthesized samples in both irradiation modes as compared to the oxidation with dissolved oxygen and essentially approached the efficiency of synthesized photocatalysts to standard Degussa P-25 TiO 2 . On the whole, N-TiO 2 was most active among the synthesized photocatalysts. No clear dependence of the HA destruction degree on the Fe content in the samples (Fe,N-TiO 2 ; 0.25–1.0%) were established at studied destruction parameters. In general, the codoped samples (Fe,N-TiO 2 ) essentially inhibited HA destruction and, in a neutral medium, the inhibiting effect became stronger with increasing iron content in a sample in both irradiation modes. It seems probable that the recombination of photogenerated electron–hole charge carriers was intensified due to the selected method of N-TiO 2 codoping with Fe 3+ ions or the range of dopant concentrations.
chemistry, physical, applied, analytical
What problem does this paper attempt to address?