Abstract:Efficient use of material is an important factor in achieving economical and sustainable structures. Typically, annealed austenitic stainless steel has a material strength of around 220N/mm2, somewhat lower than that of common structural carbon steel grades. This lower strength, coupled with the higher material cost, puts stainless steel at a significant disadvantage when considering material selection, despite its other desirable properties. However, the strength of stainless steel may, at relatively low expense, be considerably enhanced through modification of the chemical composition and through the process of cold working due to the strain hardening nature of the material. This strength enhancement has not generally been utilised in practice due to a lack of knowledge on the structural behaviour of this high-strength material. Given the high material cost of stainless steel, the need to optimise the efficiency of design methods and to develop the performance, availability and diversity of the current product range is clear. To this end, this paper describes tests, numerical modelling and the development of design guidance for high-strength stainless-steel members in a range of structural configurations. Material tensile tests, member tests in compression and member tests in bending have been described. The results of the tests have been successfully replicated numerically, and subsequent sensitivity studies and parametric studies have been performed. Test and numerical results have been compared against two design methods developed for standard-strength material (Eurocode 3 Part 1.4 and the deformation capacity based design method). The comparisons have revealed that both design methods provide a similar level of reliability to that offered for standard-strength material, and thus, extension of both design methods to the high-strength grades has been recommended.

Structure and Mechanical Properties of High-Strength Structural Steels

Stability of Structure and Properties of Nitrogen High-Strength Austenitic Steels Under Cyclic Thermal and Mechanical Loads

Martensitic-austenitic steels for the fabrication of equipment and other articles in instrument making

Light-weight Isometric-Phase Steels with Superior Strength-Hardness-ductility Combination

Behavior of High Strength Structural Steel at Elevated Temperatures

Nature-Inspired Hierarchical Steels.

Mechanical properties and deformation mechanisms of a novel austenite-martensite dual phase steel

Structure and mechanical properties of high strength austenitic Mn–Ni–Cu–V–C dispersionally hardened steel

Deterioration of Mechanical Properties of Novel Constructional Steel Material at Elevated Temperatures

Role of the martensitic microstructure in the stabilized residual stresses under cyclic loading and in the fatigue behavior of two steels

Static and dynamic mechanical behavior of high-strength 22SiMn2TiB armor steel and welded structure

Microstructure, mechanical properties and strengthening mechanism of high strength hot-rolled ferrite-martensite dual phase steel

Research advances on mechanical properties of high strength structural steels

Comparative Study of High-Cycle Fatigue and Failure Mechanisms in Ultrahigh-Strength CrNiMoWMnV Low-Alloy Steels

A Novel 1500mpa Economic High Strength Steel

Damage Mechanisms and Mechanical Properties of High-Strength Multiphase Steels

Research Progress on the Mechanical Property of High Strength Structural Steels

Structural design of high-strength austenitic stainless steel

Analysis of phase transformation thermodynamics and kinetics and its relationship to structure-mechanical properties in a medium-Mn high strength steel

Effect of Mn content and strain rate on mechanical properties of high-C high-Mn austenitic steel

The Properties of 1500 Mpa Grade Alloy Steel with Carbide Free Bainite/Martensite Mixed Microstructures