Abstract:Purpose: The aim of this study is to develop a test bench, which integrates different complexity levels and enables in that way a flexible and dynamic testing for mid and long term intervals as well as testing of maximum loads till implant failure of different osteosynthesis systems on the mandible. Material and Methods: For this purpose, an analysis of the state of the art regarding existing test benches was combined with interviews of clinical experts to acquire a list of requirements. Based on these requirements a design for a modular test bench was developed. During the implementation of the test stand, functional tests were continuously carried out and improvements made. Depending on the level of complexity, the test bench can be used either as an incorporated variant or as a standalone solution. In order to verify the performance and the degree of fulfilment of the requirements of these two variants of the test bench, preliminary studies were carried out for all levels of complexity. In these preliminary studies, commercially available osteosynthesis and reconstruction plates were investigated for their biomechanical behaviour and compared with data from the literature. Results: In total, fourteen test runs were performed for the different levels of complexity. Firstly, five test runs were executed to test the simplified load scenario in the incorporated variant of the test bench. High forces could be transmitted without failure of the miniplates. Secondly a quasi-static test scenario was examined using the incorporated variant with simplified load insertion. Five experiments with a number of cycles between 40,896 and 100,000 cycles were carried out. In one case the quasi-static testing resulted in a fracture of the tested reconstruction plate with a failure mode similar to the clinical observations of failure. The last four test runs were carried out using the standalone variant of the test bench simulating complex load patterns via the insertion of forces through imitated muscles. During the test runs joint forces were measured and the amplitude and vector of the resulting joint forces were calculated for both temporomandibular joints. Differences in the force transmission depending on the implant system in comparison to the zero sample could be observed. Conclusion: The presented modular test bench showed to be applicable for examination of the biomechanical behavior of the mandible. It is characterized by the adjustability of the complexity regarding the load patterns and enables the subsequent integration of further sensor technologies. Follow-up studies are necessary to further qualify and optimize the test bench.

Design study of dynamic mechanical test bench specimen grips

Definition of test parameters for dynamic mechanical testing of polymeric implant materials

A novel 3D-printed clamping interface for the tensile testing of biological specimens

Predicting Mechanical Properties of Polymer Materials Using Rate-Dependent Material Models: Finite Element Analysis of Bespoke Upper Limb Orthoses

Design of novel test rig for prosthetic finger distal interphalangeal and phalanx strengths

Optimization of Product Handle Material Mechanical Properties for Improved Ergonomics Using Finite Element Method and Subjective Response

A Miniaturized Device Coupled with Digital Image Correlation for Mechanical Testing

Concept development of a method for identifying friction coefficients for the numerical simulation of clinching processes

Novel Design of Cruciform Specimens for Planar Biaxial Testing of Soft Materials

Three-dimensional finite element simulations of the mechanical response of the fingertip to static and dynamic compressions

A Novel, Inexpensive and Easy to Use Tendon Clamp for in Vitro Biomechanical Testing

Design and fabrication of an adhesion force tester for the injection moulding process

Mechanical design, modeling, and identification for a novel antagonistic variable stiffness dexterous finger

Micro-tensile tests on micromachined metal on polymer specimens: elasticity, plasticity and rupture

A Metamaterial Computational Multi‐Sensor of Grip‐Strength Properties with Point‐of‐Care Human‐Computer Interaction

Design and Analysis of a Hand-Held Surgical Forceps with a Force-Holding Function

Development of a test bench for biomechanical simulation—a preliminary study of mandibular forces

Design of a Test Bench to Characterize Mechanical Phenomena Involved in a Bolted Joint

Design and Analysis of Soft Grippers for Hand Rehabilitation

Dynamic Simulation Analysis of the Mid-Strain-Rate Tensile Testing Machine

Design of a Mechanical Exoskeleton System for Improving Hand-Gripping Force